Production technology of cloisonne painting

The production process of cloisonne enamel painting is as follows:

1 First, you need to choose a good picture on the floor.

2. Mix colored sand, sand-fixing glue and water 1:3 with your sand as shown in the figure, and the liquid is about 1 cm higher than the sand surface.

3. Start pasting silk after painting. You need to apply glue to your finished line draft, let it dry for a while, and then you can start to stick the silk by touching the glue surface with your fingers without drawing. Put the silk on the glued thread and press it for a few seconds.

4. After all the lines are glued with silk, you can start sanding and fill the color with the sand you have adjusted before. The height is 1/2 or 2/3 of the vertical height of the glue wire, which is too full and easy to mix colors.

5, the color is good, you can spray a layer of glue, so that it is a matt surface after drying; Or wait for it to dry before sticking the cover of AB glue, so that it will have a mirror effect after drying. If it is dry with AB glue, be sure to pay attention to dust prevention.

Precautions:

1, choose a thick PVC board for the bottom plate, add a wide circle of silk at the edge of the board or buy edge banding.

2, the silk should be stuck to the narrow side. When it is not smooth, you need to lick the silk with a small piece of wood, and then stick it smooth.

3. Sand should be adjusted in advance, and bubbles need to be discharged. First add water and then reinforce the sand glue.

4. When applying glue, you should look at your own hand speed, and avoid coating too large area to dry without sticking sericin.

5. Cut the wire vertically.