How to tie a knot at the end of a bracelet red cord

01

Flat Knot:

After bringing all the strands at the end of the bracelet together, pick up a piece of string and tie a knot positively at the end of the closure.

02

Reverse knot.

03

Tie a knot forward.

04

Repeat steps 2 and 3 (usually 8 knots are enough).

05

Just cut off the excess after tying and burnish the thread to prevent unraveling.

06

Button knot:

After the bracelet is put on, according to the picture below, one end will be vertical, and the other end of the loop out of a circle, pay attention to the lower end of the line for the end of the line, as shown below in the direction of the arrow.

07

Fold the loop from the previous step upwards in the direction of the arrow as shown below.

08

Wrap the left end of the cord tail around the right end from below, followed by the top through the wound circle, in the direction of the arrow in the picture below.

09

Wrap the right end of the cord tail around the left end from above, then underneath through the wound circle. Then pass the left end of the cord tail underneath around through the center of the second circle, in the direction of the arrow in the picture below.

10

Pull the end of the cord tightly outward so that the button knot is finished.