How to make path animation? Let the object move with the path

First, draw an original. Take a rectangle as an example here. Draw a rectangle first.

Select it and press F8 to convert it into a component.

At this point, you can add a path. First, add the boot layer to the layer where the object is located. Right-click the layer and select Create Traditional Motion Guidance Layer.

Draw a path on the first frame of the new guide layer with a pencil.

Then, we move the object to the far left of the path in the first frame of the object.

Suppose we plan to move the object to the end of the path after 70 frames, just copy the contents of the first frame at the position of the 70th frame and press F6 at the 70th frame of the object layer. Then pull it to the end. Press f5 at the 70th frame of the startup layer to display the path.

Right-click the middle frame to add traditional tween animation.

end

Matters needing attention

A pencil was used to create the guide layer.

Remember that when an object presses f6, the boot layer should press f5, otherwise only the first frame will be visible.