How to pedal a motorcycle's gear?

The operation of driving a motorcycle to shift gears is described as follows:

1. Before starting, the motorcycle is in neutral, and the feeling of the foot pedal is slack.

2. Prepare to start, hold the clutch rocker arm with your left hand to disengage the clutch, press the gearshift lever down by one frame with the palm of your foot (each foot shift needs to be operated while holding the clutch tightly again), and the gear is put into 1st gear.

3, slowly release the clutch rocker arm, release to 3/4 position and then relax the clutch rocker arm while turning the throttle knob to increase the throttle, increase the engine speed, so that the engine power to the rear wheels. When the rear wheels rotate, release the clutch rocker arm completely, so that the clutch is combined, so that the starting operation is completed.

4, the next is the gear operation, slightly increase the throttle, the speed slightly increased.

5. Close the throttle (turn the throttle knob forward and downward with your right hand to the end), quickly grip the clutch handle, and use four fingers of your left hand to grip the clutch handle to the end, and when you grip the clutch, place your foot on the lower end of the shifter, and lift the shifter up a notch.

6, the left hand release the clutch, the right hand crank the handle to accelerate the throttle to speed, the gear successfully hung into 2nd gear.

7, the same way, in turn, can be hung to the highest gear. In the case of skilled operation, you can also ensure that the speed of the car in the case of a clutch operation, to complete a number of gear switching, for example, through the foot operation, continuous upward lift of two frames, the 2 gears to 4 gears.

8, then the downshift operation, the left hand clutch grip, while the right hand off the small throttle (if the car speed is too fast, you need to use the brake to slow down).

9, the palm of the foot to the upper end of the gearshift, the gearshift down to the lowest, complete the 2nd gear down to 1st gear.

10, the next step is to stop the car, observe the surrounding road conditions, hold the clutch grip tightly with your left hand, at the same time turn off the gas pedal with your right hand, and use the brake to reduce the speed to 0.

11, after the vehicle stops, your left hand can not let go of the clutch, and put your foot on the lower end of the gearshift, lift the gearshift up one frame, and the gearshift will enter the neutral gear.

12, after the neutral gear, the left hand can release the clutch, put down the support pedal, the driver get up and leave the vehicle.