How to open the fishing material

One, the modulation of the bait: the choice of single product finished bait Carefully read the instructions quickly to understand the bait water ratio and bait specific gravity, solubility, etc., in order to facilitate the use of the bait through practice to understand the performance of bait. Second, the use of commercial bait 1 Select a basin with a larger bottom and food bowl and measuring cup, determine the proportion of bait and water, first pour the bait into the basin, thinly spread on the bottom of the basin. After pouring in the water, let the water penetrate with the bait naturally and mix evenly. Note that many commercial baits containing wheat protein are highly absorbent and grab water very quickly. If the powder layer of the bait is too thick, the surface layer of the bait will grab all the water, leaving the bottom layer of the bait half-dry and half-mixed, which will not be able to produce the ideal bait, and you can only reuse the bait for other purposes or dump it. 2. After adding water, the wheat protein fiber in the bait will take some time to absorb water and develop into silk with other ingredients in the bait. If you don't leave it long enough, rubbing and kneading will affect the expansion effect of wheat protein fiber to destroy the even distribution, resulting in uneven specific gravity of the bait. 3. Even if the bait is ready, it is better not to knead it too much or knead out a small ball beforehand, which will affect the setting effect of the bait. 4. Don't expose the snowflake-shaped wheat protein type bait to sunlight and air too much, because it will absorb the moisture in the air, which will make the bait ball become thin and can't be used normally. Therefore, it is better to mix enough bait for 1~2 hours each time, not more than one, and it is better to mix it now. 5. It is recommended to choose or mix the bait with the viscosity suitable for the fishing conditions. Don't knead the bait after it is ready, because the purpose of kneading is to increase the viscosity; don't knead the bait, keep the bait in the natural state, which will make the air in the bait, the bait and the water evenly distributed, and keep the bait setting effect. In the water, if there is no air in the bait, its specific gravity and solubility will be affected. Third, the modulation of commercial bait 1. Use a measuring cup to take the required amount of bait, gently compact the bait in the cup, so that the amount of bait is accurate. 2. The bait into the dry wide bottom and food bowl, evenly spread, make sure not too thick, to half the thickness of the index finger flat is good. 3. Use a measuring cup to take the right amount of water quickly into the basin, shaking quickly in one direction, so that the bait absorbs water evenly, to be fully absorbed by the bait after placing the end of the expansion process (3-5 minutes in summer, about 30-60 minutes in winter) 4. Fingers will be inflated bait from the bottom of the basin gently turned up, and then placed for a while (it is best to wet your hands beforehand) ), so that the part of the bait that has not been fully inflated will be fully inflated. 5. Take out the part of the bait you want to use and gently roll it into a ball; cover the other part of the bait bowl with a semi-wet towel and set it aside in a cool place. To make the bait soft or hard, adding water is the key. Adding or subtracting water can also control the specific gravity and solubility of the bait. However, you should try to add or subtract water little by little. The methods mentioned here are only applicable to most of the commercial baits, different amount of water can determine the different properties of a bait 1, how to control the atomization speed of the lasso bait: you can add some sticky bait, such as Maruyuki's Alpha 21, or hit it lightly for a few times (pay special attention to the fact that you can't hit it more than once, or it will become gluten). 2, how to control the length of the fiber of the lure: you can add short silk bait, such as the old ghost of the fast attack, or the bait a few times, to shorten the fiber. If you add powder, you can make the fiber longer. 3, how to control the specific gravity of the bait: the general bait bag will be marked specific gravity, you can mix according to the need. If not labeled. Then only try it yourself, try to remember. In addition, the general specific gravity of the bait, in the appearance can be seen. The specific gravity of more particles is generally larger. 4, how to control the pull out shape of the bait: the first three control, the rest is the proportion of bait and water. First, according to the bait's bag labeled water amount is OK. Secondly, if you want to make the bait smaller and stickier, just give it a few strokes and use a slightly higher proportion of water. If you want to pull the bait bigger, use less water. Remember, at all times, do not hit the bait hard. Do not knead. Add enough water at one time, then put the bait aside to wake up after it has absorbed enough water. When the bait is ready (5-10 minutes), put it into a pile, put it in the palm of your hand, and squeeze out the air with both hands to form a ball. Put it on a bait tray and pull it. When pulling bait to fish floating, you should use the bait with light weight, require fast atomization, and use the buoy that turns over fast and sinks slowly to match. Pull bait fishing bottom, should be used than the weight of heavy; hook force strong bait, to be matched with carbon foot hard tail mark. Fish eat well and atomize fast; fish are cunning and sticky; fish are big and pull big; fish are small and that can't be pulled small. Pull the bait soft and hard like earlobe, can not be controlled by the soft and hard, should be controlled by the dissolution degree, the fish is slow, the fish is fast, the fish is fast is slow. When pulling the bait, lightly pull the surface of the bait, not hard, so as not to pull dead. (Bait not loose) Wake up the bait is very important, wake up the bait, that is, let the bait with good water to fully absorb the water, so that the bait in the wheat protein from the powder into the silk mesh. This way, the bait can be molded to make the bait in a good shape. When the bait is not full of water, such as pulling the bait, the fiber is not sent out, and you may not be able to pull the bait out in a satisfactory condition. In summer, it takes shorter time (about 3-5 minutes); in winter, it takes longer time (about 10-15 minutes). The bait with heavy weight sinks fast in half water, the fish are not easy to float, the fish are not noisy when fishing on the bottom, it can be held down, and it is usually used for fishing on the bottom. For example:918 2# The bait with small weight is necessary for fishing a standard deep and fast fish, it is fast atomization; slow sinking; easy to lead the fish in the same fishing shed long lasting, not fishing deep water pond. [The master bait, is the different bait, according to the fish, regulating the specific gravity: the floating transfer light; the bottom transfer heavy; shallow water is light; deep water is heavy program, the deployment of bait]. This is the words of a master. I'm still not this fire ~ Oh ~ Note: the difference between wheat protein and 5 # carp Wheat protein fiber is pure, which does not contain snow powder, do bait is mainly viscous, but the old ghost 5 # is with snow powder, increasing the degree of looseness between them, know that there is a snow powder wheat protein bait, in the rear release to give full play to the advantages of its looseness. How to make red worm bait - put 1/2 of the red worm reamed into small pieces (with blood) into the unseasoned bait powder; in the bait, the proportion of the powder is a little bit bigger (about 15%), mix it well and then mix it with water 1:1.1; lastly, put the remaining 1/2 of the whole red worm into the seasoned bait gently (less often). Supplementary note - the composition of the bait powder can be varied! But there is one **** same point - all of them are made of one or several kinds of powder bait as the base material, with the pulling powder as the supplementary material. The base material emphasizes the bait's palatability and fish-attracting effect! The auxiliary material (drawing powder - wheat protein fiber) emphasizes on changing the physical properties of the bait, increasing the stickiness and extensibility of the bait. Base material can be any kind of powder bait or several kinds of powder bait (Dongjun. Scented Carp. Daxin Carp. New b---------- etc.) The proportion is 90%; the proportion of drawing powder is about 10% (if the base material is labeled as rollable or pullable, the proportion of drawing powder should also be reduced to 5-6%). I hope it will help you a little bit.