How to make a mousetrap simply

1. Drill a hole at the center point of one third of the rectangular board with a hand electric drill and screw in the long nut.

2. put the coke bottle on your finger, measure it and find the balance point. At the center of the balance point, drill a hole with a hand drill.

3. The long nut passes through the coke bottle and is locked on the long board. The bottle mouth faces the end of the board away from the drilling hole, and then the two sides of the bottle are basically balanced.

4. Then 5 1 freebo. Coat one side of the short board with hot melt adhesive and stick it on the long board near the bottle mouth. The board should be as close as possible to the bottle mouth, but it should not affect the fluctuation of the bottle mouth.

Teach you how to make an environmentally friendly DIY mousetrap with a coke bottle.

When the bottle mouth end is horizontal, it should be close to the surface of the board, and the lower edge of the bottle mouth end is just at the edge of the board.

A simple mousetrap is ready. Put a piece of bread in the bottle and stuff it at the bottom of the bottle, so that the mouth of the bottle will be higher than the short board, which is convenient for mice to enter.

6. When the mouse wants to eat bread, get into the bottle and come out again. Because of the weight of the mouse, the bottle mouth will be pressed down, and the mouse will naturally not get out.