Buddha bead bracelet elastic cord how to tie a knot

1, first of all, the Buddha beads will be strung in order with elastic cord.

2, and then the two lines cross, as shown in the picture below.

3, then repeat the knot twice to make the knot tighter.

4, pull the end of the thread into the hole of the first bead you string, which can prevent the end of the knot from falling apart, but also beautiful.

5, and finally organize the distance between the beads to make it even and beautiful, until you can not see the thread when it is completed.

Expanded

Maintenance requirements:

One, do not wear other metal jewelry at the same time when wearing the Buddha bead bracelet, in order to avoid collision deformation.

Two, avoid contact with water vapor and chemicals, don't wear swimming, especially in sea water.

Three, if you have plenty of time, every day after wearing with cotton sassafras clean, put into the jewelry box to save.

four, buddha beads bracelet due to wear and dust, you can use soft bristles brush dipped in toothpaste brushing, washing to use cotton sassafras dry can.

Fifth, the maintenance of the Buddha bead bracelet should often touch the jewelry with your hands, will enhance the luster of the bracelet.

Sixth, wash your hands when it is best to remove it, soap contains alkaline substances will damage the Buddha beads and affect the luster of the Buddha beads.

Seven, be careful not to contact acid, alkaline substances, to avoid cosmetics staining the Buddha beads.

VIII, wear bracelets in order, wear first, and then wear bracelets, to avoid wearing hooks to the clothes, resulting in the beads of the Buddha fall off.

Nine, carry a small jewelry bag, to avoid washing hands and remove the bracelet on the sink, accidentally fall to the ground broken.