How to install the floor press?

Step 1, before the installation, you need to check the installation area of the water and electricity lineup, to prevent mistakes. Check for errors, start drilling holes, keep the appropriate distance between the holes, so as not to press the strip can not press the wall. Need to use a specialized utensil to drill holes. The general length of the pressure strip is two meters, so that the pressure strip closer to stable and firm, the hole spacing should be roughly keep forty centimeters, the pressure strip interface spacing should be set smaller, and then nail the wooden strip in order to the eyelet inside the head.

Step 2, the need to fix the pressure strip of nails into the previous eyelets on the wooden strips, driven into the wall, to prevent the wooden strips too loose.

Step 3, because there are families with water and electricity circuit piping go to the wall, the general outlet area below the laying of water and electricity circuit piping, we need to calculate the spacing when punching holes, so as not to damage the layout of the water and electricity.