Photovoltaic panel installation method

The photovoltaic panel installation method is as follows:

Select the appropriate installation location and orientation, adjust the angle of the power generation panel according to the location, ensure good and sufficient lighting conditions, and avoid being blocked by buildings or greenery The installation ground must be flat, and it is best to install it on a sloped roof. Install the solar bracket first, make sure the bracket base is welded firmly, tighten the screws, and use high-quality stainless steel to withstand harsh weather such as exposure to the sun and strong winds.

Install the battery panel into the bracket. The voltage of the Kumquat system will determine how many panels need to be installed. Fix each panel with screws. Select cables with appropriate current load sizes to connect the components of the battery panels in series and parallel to form a power generation array to meet the power generation output demand. Be careful not to reverse the positive and negative poles of the positive and negative terminals, and finally connect them to the controller.

Advantages of solar power panels

1. Resource advantages

Solar power panels can generate electricity by absorbing solar energy without consuming other fuels. Our direct access to solar energy resources is inexhaustible and permanent. More importantly, solar energy resources are everywhere and do not require mining and transportation and can be directly utilized.

2. Energy saving and environmental protection

The production material of solar panels is silicon. The solar power generation system is only equipped with all battery components. It can generate electricity when the sun shines, and does not produce any energy during energy conversion. Emissions, such as carbon dioxide, can effectively reduce the greenhouse effect, have a high energy conversion rate, and are very clean and environmentally friendly. There is also no noise pollution and radiation pollution. Although the initial cost of installation is high, the maintenance cost after actual use is low.