How to install the double columns of the balcony indoor lifting clothes rack

1. In any corridor where the hand is installed first, measure the position where the hand needs to be installed, install the expansion rubber plug with an electric drill and tighten it by hand.

2. Then throw out all the wire ropes in the vibrator. When throwing the wire rope, be sure to tighten the wire rope to avoid losing it until the handle can't turn.

3. Determine the installation position of the pulley bracket. Pulley brackets are installed at four points on the ceiling, on this side of the double pulley frame of the nearby corner detector. For example, for a single roller bracket, the single roller bracket should be larger than 27 cm.

The distance between the two sides of the wall and the distance between the two single pulley brackets is more than 45cm, while the average distance between the single roller bracket and the double pulley bracket is 2m, but the environmental conditions for final installation are finally determined.

After determining the installation position, mark and mark the hole position, and then punch holes in the installation hole position.

4. After drilling, assemble the expansion screw with four pulley frames.

5. After assembly, install two double pulley frames and two single pulley frames on the machined holes.

6. Assemble the rotor with expansion screws.

7. Determine the installation position of the rotor. The position of the rotator must be 90 degrees perpendicular to the position of the crank.

8. After determining the installation position, mark and punch holes, and then install the assembled turntable.

9, the first step through the steel wire, respectively, winding steel wire, two steel wire clip inside, they first enter the corner.

10, then both ends of the wire rope pass through one of the double roller frames, and they are parallel and not wound. The wire rope of the wire rope is close to the hand under the double-wheeled frame, and the other end is pulled in the corner. The other wire rope is operated in the same way, then the wire rope of the button is shaken out by hand, and the wire rope is hung up to complete the same operation as the other wire rope.

1 1. Install the lifting ring, cut the four ends of the steel wire just tied flat, pass through the lifting ring and tie it tightly.

12. Install the clothesline and fix the four hanging rings on both sides of the clothesline.