What is the process of a general painting factory? What tools does painting rely on?

1. Wall treatment

The foundation treatment of the wall is more important. Generally, it is painted on the wall with latex paint, so the leveling, priming and pattern planning of the wall should be prepared in advance.

Make a manuscript

People without artistic skills should draw a good draft on the wall, gently tick the outline of the draft with a pen, and then draw it after they are satisfied, otherwise it will be difficult to modify it.

Mix with paint

Buy paint according to the pattern effect. If you are not sure about the color matching effect of latex paint when you buy it, don't make a decision in the paint shop. You can take color swatches or paint samples home and observe the paint color under natural light and night light respectively. High gloss paint will make the room look brighter, but it is also easy to highlight the shortcomings of the wall. If the wall is uneven, it is recommended to use matt paint. The paint must not be too thin, otherwise it will easily leave flow marks on the wall. Acrylic pigments can be colored as needed, so write carefully.

Prepare for coloring

First, spread a newspaper in front of the wall to be graffiti, so as not to dirty the ground. When hand-drawing a pattern with simple color, first draw an outline on thin and absorbent paper, then cut it out, put it on the corresponding position on the wall and color it with rubbings. If you are afraid of damaging the wall, the most convenient way is to spray glue, carve the picture after spraying and stick it on the wall with glue. When acrylic paint is painted, if mistakes are found, it can be wiped off with a wet rag and repainted, but latex paint cannot be painted in this way.

5. Maintenance

Ventilation after painting, and then touch the wall after drying. Although acrylic pigment is waterproof and scratch-resistant after drying, do not scrub it with water.