There are several ways to tie the hook.

The following three kinds are commonly used to tie fish hooks.

The first method is to circle first and then knot.

This method is the first hook tying method that many anglers learn. The operation is very simple, and it takes three steps to tie it.

1, along the hook handle, wind the fishing line around the hook handle, with the small hook winding 4 times and the big hook winding 6 times, leaving a thread end of about 4 cm at the bottom of the hook.

2. Close to the fishing line at the handle of the hook, make an opposite coil and insert it from the hook tip. In this way, when passing through the two coils, be sure to press the thread end on the bottom of the hook.

3. Pull the line at the bottom of the hook with pliers, pull the fishing line at the handle of the hook by hand, and tighten it hard to cut off the redundant line at the bottom of the hook. The other hook does the same, and the two hooks are tied together.

The second method, double finger winding.

This method is called the fastest knotting method. There is a merchant in Tianjin fishing gear exhibition. In this way, 1 min has tied 36 toll lines, which is amazing and its operation steps are not complicated.

1. Make a coil, press two fishing lines parallel to the hook handle, leave 3~4 cm of fishing line facing the hook bottom, and hold the two fishing lines and the hook handle by hand.

2. Extend the index finger and middle finger with the other hand, unfold the coil, and bypass the hook tip from the hook bottom and hook handle. Press two fingers down around the handle of the hook and continue winding. After winding for 4~6 times, continue to hold the fishing line and hook handle with your fingers.

3. Pull the thread end at the bottom of the hook with pliers, pull it down hard, then pull the fishing line at the handle of the hook, and pull it up gently to ensure that the fishing lines are tightly tied together, cut off the excess thread end at the bottom of the hook, and tie another hook according to the above method, and the double hook binding is completed.

The third method is hook handle winding.

This method is widely used in old birds, not to say that it is easy to use, but that the hook tied by this method is the strongest and the steps are a little cumbersome, but this method is basically unlikely to get off the line.

1. Parallel the fishing line along the hook handle to the hook bottom, leaving a fishing line of about 6 cm, press the fishing line and the hook handle upward, and leave a tongue buckle at the hook bottom.

2, the rest of the fishing line, from the hook handle to the hook bottom, press the fishing line and the hook handle to start winding, about 5~8 times.

3. Extend the line from the left tongue buckle, pull the line, and gently pull the fishing line at the hook handle.

4. Turn the coil of the fishing line, press the groove on the handle of the hook, then clamp the thread end at the bottom of the hook with pliers and pull it hard. When a single hook is knotted, the other hook can be operated in turn.