How to wire the household 5-hole switch panel?

The connection diagram of a five-hole line with one opening is as follows:

Connection method:

The live wire enters the five-hole L wiring hole, and a live wire is connected in series from the wiring hole to the L position of the switch. When the control line of the lamp (that is, the live wire of the lamp) is connected to L 1, the blue zero line is connected to the five-hole N wiring hole, and so is the ground wire.

Extended data

Misuse:

1, less cycle

There is only one circuit in the old house. Once any line is short-circuited, the electricity consumption of the whole room will be paralyzed. Generally speaking, the socket can choose two or three loops, one for the kitchen and one for the bathroom, and one for the air conditioner.

2. Use the old national standard

Universal hole socket, that is, the jack can be compatible with two or three poles at the same time, even if it is a socket with non-daily plugs such as British standard, American standard and European standard. However, due to the large jack and the small contact area between the contact piece and the electric plug, this socket is easy to overheat the contact piece and lead to fire accidents.

Step 3 Install at will

The power cord must use copper wire section. If you live in an old house, you must replace the original aluminum wire with copper wire. Because the aluminum wire is easy to oxidize, the joint is easy to catch fire. A survey shows that the incidence of electrical fires in houses using aluminum wires is dozens of times that of copper wires.

Baidu encyclopedia-socket