What is the material of medical cleaning board? Construction technology of clean ceiling

There are many kinds and styles of plates, but many people may not know much about plates, so there will be many doubts when choosing them. Do you all feel suspicious about what material the medical clean version is made of? Then take a concrete look at the following introduction. There are many kinds and styles of plates, but many people may not know much about plates, so there will be many doubts when choosing them. Do you all feel suspicious about what material the medical clean version is made of? Then let's look at the following introduction specifically. When you pay attention to the ceiling, you may choose to use clean board, so it is necessary to understand the construction technology of clean board ceiling.

What is the material of medical cleaning board?

For the medical clean version, in fact, the medium density fiber cement board is used as the basic material, and then UV paint is used as the raw material to decorate the board through UV curing process.

UV paint coating is attached to the surface of the plate, and instantly solidified into a film by ultraviolet irradiation, with high curing content, high hardness, smooth surface and good antibacterial ability. UV clean color board is mainly used for wall decoration of medical clean rooms, operating rooms, ICU wards and corridors.

Construction technology of clean ceiling

1, install the keel boom.

Locate with the prepared horizontal line and the dividing line of the main bone of the rear keel. You can make the height lower than the boom. According to the keel dividing line, and set the hook distance of the keel boom. First, buckle the side without screws on the arranged steel bars and put them away. The screws that have not been put in place can be fixed with some expansion bolts first.

2, keel installation mode

First, select the nut of the boom. Install the hanger on the trunk bone, and then hang the set trunk bone of the hanger at the position of the dividing line and pass through the corresponding hanger bolt. Fixing screw. Hang a hanger at the joint of the main bone. Connect and adjust the height. Its connection and parallel line are connected to the keel hole to add the keel and observe the structure of the corresponding point. At the same time, the firmware of the link card is also set, and then the fixed edge can be locked and the position can be stabilized with nails, but the distance between the two should be separated while stabilizing the position.

3, install the secondary dry bone

According to the set accessory bone parting line, accessory bone hanger with one-to-one corresponding room number and accessory bone installation, a certain distance should be made one by one according to the designed scheme, accessory bone hanger should be hung on the main bone, when accessory bone needs more links to extend. You can choose the linker of the secondary skeleton and connect them together when installing the secondary skeleton.

Step 4 install the ceiling

When installing the ceiling, all kinds of linked solid pipe fittings in the ceiling must be accepted to see if there are any minor problems. Small problems must be followed up in time, and the ceiling can only be installed after passing certain suppression tests. When installing the ceiling, adjust the straightness between the dragon turtle and the frame, and pay attention to opening different interfaces of the ceiling during installation.

What is the material of medical clean board and the construction technology of clean board ceiling has been introduced for you? Do you understand after reading it? In fact, the ceiling construction must invite special staff, so that the steps will be more reasonable and the installation effect will be impeccable. Then there is the choice of plate. Be sure to go to a regular store to choose, don't worry about quality problems.