How to adjust the drift of black pit crucian carp

The bleaching method for fishing crucian carp in black pits is as follows:

First, grab the fishing drift. When fishing in a black hole, it is best to adjust it to 5-8 meshes. The specific mesh number depends on the size of bait used in fishing. If the bait is large, it should be raised a little. Lower the light bait or small bait. Generally speaking, crucian carp weighing more than three or two will look up and eat bait. At this time, the probability of catching fish is very high. The upward adjustment is for big fish and slippery fish, and the downward adjustment is for light-mouthed and weak-mouthed fish.

Second, the skills of fishing crucian carp. If you are fishing in the old pond, try not to lower it, and sometimes you can adjust it to the drift tip. If the target fish is raw fish, there is generally no slip or dead mouth, and it can be adjusted to 7-8 meshes.

Third, the selection, bleaching and stringing skills of raw crucian carp. When fishing raw crucian carp, the drift net is generally above 15 mesh, which is convenient for observation when fishing. Secondly, the dividing line should be as long as possible. If the sub-line is too short, the lead can be moved up by about 15 cm. Doing so can increase the swing of the auxiliary line, slow down the sinking speed and facilitate the fishing section. The more you chop, the more likely you are to fish.

Fourth, the black pit drift of swimming pool reconstruction. The swimming pool is airtight, so when fishing, you should first choose the fishing ditch. Because the oxygen content is low and the fish are in the upper layer, it is necessary to improve the mesh number, reduce the sinking of bait and facilitate fishing.