The most effective way is not to catch the fishing rod if it is stuck.

First, it may be that the inner layer of the rod joint of the fishing rod is worn and even deformed after a long time of use. In the process of fishing, the rod is often lifted by external force, or the fish is large. In the process of lifting the pole, excessive force leads to jointing, and when the fish struggles, it tends to drown, which is also easy to lead to jointing.

Second, improper operation and excessive force lead to jointing. Many fishing friends, when they arrive at the fishing point, can't help but be excited. They quickly debug the equipment and want to serve fish early. Pull out the rod quickly, but the force is too large, and it is inevitable to pull out the joint under the action of inertia.

3. In the process of fishing, there are duckweed and Tess in the water meter because the water meter at the fishing point is not clean. When fishing in muddy water, there are sediments or floating objects (impurities) in the water. In the process of pressing the waterline, these dirt will stick to the rod body. How to clean and maintain it in time after fishing, so that the fishing rod will be caught by foreign objects next time. Fishing rods with defective quality are also easily caught by burrs between rod sections, forming joints.

It's normal for fishing rods to be out of touch. Don't panic when dealing with it. A watched pot never boils.

Method 1: unscrew the tail plug, put a piece of cardboard flat on the ground, put the handle of fishing rod flat on the cardboard with your left hand, and then throw two spoonfuls of fishing rod inward with your right hand. It usually takes two or three times to recover. Note: be sure to put the handle on the cardboard, not on the hard ground, otherwise it will crack easily.

Method 2: Take a few drops of detergent or cooking oil and apply it to the joints. When it is fully lubricated, gently twist it to restore it. You can also throw it gently at the barrel, and be careful not to use too much force, because most metal parts are blocked by the tail, which will cause the barrel to crack.

Method 3: Take the tin foil from the cigarette case, cut it into small strips, wrap it in the joint with the tin foil facing outwards, light it with a lighter, and gently twist it when the ash is scattered. Pay attention to the details, tin foil only needs to be wrapped in one layer, not too many turns, otherwise too much heat will easily burn the rod joint or deform.

How to avoid or reduce jointing phenomenon? We should work out a correct method to pull the pole with even strength. At present, the rod section of fishing rod has many grooves. Screw the lock inward when pulling the rod, and outward when closing the rod. After fishing, clean the attachments on the surface of the rod body and wipe off the dirt with a cloth. When you get home, you can also take off the tail plug, dry it in the sun, coat it with guard rod oil and carry out some necessary maintenance.