Fountain pen how to suck ink?

Hello, the fountain pen is divided into landing on the water, vacuum on the water, the card water and ink absorber, the barrel of the integrated piston and air pressure.

General air pressure and card water, ink absorber is more common, the following method of use:

Air pressure is what we call the squeeze on the water is also called anatomical water, directly compared to the water in the water, press 5 times (the current pen are not labeled a few times, but in accordance with the experience of the 5 times can be more fully functioning) on the use of it.

How do I refill my fountain pen?

Heh, that's a question for you, have you ever come out and not used a fountain pen?

For a normal plastic capsule, just squeeze the capsule flat and let the air inside be squeezed out, several times. During the period to pick up the nib upward with a finger gently flick a few suction capsule, so that the air inside the concentration of the upper part, and then pinch the capsule (to the extent that the ink does not overflow) to squeeze the air out of the nib downward to continue to suck a few times the ink, so that the ink is filled with as full as possible.

If it is the kind of fountain pen with a suction lever, it is OK to press and pull the suction directly.

How do you suck the ink out of a fountain pen like this?

This is a disposable ink capsule, you need to buy a replacement capsule, it can not absorb ink. If you want to get a fountain pen that sucks ink, you need to buy a matching ink sucker.

Why does a fountain pen suck up ink

Using atmospheric pressure. The fountain pen discharges the air inside the tube, the external atmospheric pressure is greater than the air pressure inside the fountain pen ink tube, the ink is pressed in

Parker fountain pen how to suck the ink

will not valve do not have to worry about that thing is not at all high break, there are two kinds of, a kind of rotary, one is to pull the pull of the pull of the one that is only a few dollars, the rotary is nothing more than twenty or thirty dollars, a lot of fountain pens are used in this way on the ink, nothing special, to pull to the point of the ink, and then pull to the point of the ink.

My fountain pen how to suck ink 40 points

You open the fountain pen set, which is pinched you put the pen into the ink pinch, if it is a push-pull on the fountain pen set of the thing pushed to the bottom, and then put the pen into the ink, a pull on the line

Parker fountain pen, the fountain pen, the ink, the ink, the ink, the ink, the ink, the ink, the ink, the ink, the ink, and the ink. p>

Parker fountain pen how to suck ink

Parker's suction device has two kinds of ink, a spiral, a pull, spiral is the nib to put ink, a hand pinch the pen, a hand to rotate the back end of the suction device; pull on the suction device has a can be pushed and pulled on the thing, the first pushed to the front, and then the nib to put the ink and then pull the back end of the good. Carbon ink is not recommended, too many impurities, generally use a month or two to clean it, pull down the ink absorber, the rest of the nib part of the pen soaked in water overnight, the next day under the faucet rinse on the good. If you still do not understand can go to the store to ask, I know that Jiefang Road, the original Iron Technology College across the street there is a culture of the East Provincial Seismological Bureau diagonally across the street there is also a

fountain pen how to suck ink

( the correct way into the ink

① will be at the end of the pen end of the sucking piston rod as far as possible to rotate out.

② Place the nib in the ink and completely submerge the nib to avoid inhaling air.

③ After sucking in the ink, turn the nib down and release six to eight drops of ink.

④ Tighten the piston lever with the nib pointing upwards, and let the remaining ink from the pen's tongue flow back into the ink reservoir.

⑤ Wipe the nib and tongue with tissue to complete the inking process.

There are other fountain pen knowledge a.. The correct use of fountain pens

① gold nibs to write with the front, iridium nibs written on the front will become thick, you can write on both sides.

② ink should be fixed brand, change to another ink, should be cleaned and then sucked.

③ The skin tube should always keep the ink, not to increase the air, which leads to too rapid or leakage of water.

II. After writing the words to follow the pen cap buckle good.

This can protect the nib, not to dry ink to affect the writing, ten thousand a drop, the pen cap will be able to protect the nib well. Some people said that the experience of writing, it is best to write the pen cap buckle at the end of the pen. In this way, Wan a drop, the pen tail heavier, the nib will not first land, is also a way to protect the nib. (The metal shell of the pen is best not so buckle, easy to wear shell coating).

Three. Before using the fountain pen:

1. Rotary fountain pen

a. Wipe the internal structure of the pen clean.

b. Use hot water to force out the ink. (Specific method: soak in hot water)

c. Soak the nib of the pen separately in scalding water. (5 minutes)

d. Remove and wipe the nib.

e. Assemble the pen and use it with ink after 5 minutes.

1. Tubular (i.e. squeezed by hand)

a. Wipe the internal structure of the pen clean.

b. Remove the back cover of the pen.

c. Put the pen tip into a cup with a lid multiplied by hot water and cover it for 10 minutes. (Note: the water must not be too hot, or scald the hose!)

d. Remove the lid, pinch the hose that removes the cap from the back of the pen, and lift it upward 3 millimeters from the surface of the water to squeeze out the ink in the hose.

e. While the pen is warm, it can be filled with new ink and can be used. Nib bifurcation: put the nib on the glass plate, squeeze left and right, slowly flatten the nib, and then rub the nib back and forth on the glass plate, smoothing the nib to prevent scratching the paper. This will be fine. Four. Fountain pen out of water solution

1, with warm water soak nibs, when the water is cool, solidified in the nib of the ink is also melted, then wash the pen, it can be washed clean.

2, first cleaned with water and then pumped back and forth with laundry detergent soak, and then cleaned with water afterward, so it will be very smooth.

3, the nib if there is no physical damage should be ink in the dregs of the tube blocked, disassembled and rinsed clean.

4, razor blade scratch the nib on the slit, if you want to thoroughly clean the nib, you can use a nail clipper to gently clip the nib to pull out - note: not every nib can be so pulled out, but most of the ones I've tried can be. V. Ink use

It's best to use the same brand of ink. Good ink will not damage your fountain pen.

You don't have to suck up too much ink at a time, some fountain pens will dispense too much water when they are full.

Don't mix different inks together either, it hurts the pen the most.

Note: Never use ink as ink! Because there is glue in the ink!

Six, after a period of time, should be cleaned.

Take the pen apart and immerse the absorber and nib (the part that connects the absorber to the nib) in warm water overnight. Insert the ink absorber back in, immerse the nib in warm water, then hold the ink absorber in the middle of the ink absorber with your hand and lift and press the ink absorber until it is cleaned, and finally dry it with a soft cloth and use it.

If the cleaning is ineffective, you can use alcohol to try, but be careful, otherwise it will welcome the new hand! Seven. Don't be greedy for fine writing against the nib

If you like fine strokes of the word, then buy an extra fine pen. Never write with the nib backwards. A lot of people write backwards, and I've done it too. The result is: reverse writing nibs scratching the paper, writing is very uncomfortable, the nib will get thicker and thicker, the quality of the nib will crack. Eight. Fountain pen pen crack adhesive law

Fountain pen pen rupture, scrubbing, drying available after 502 glue adhesive. The glue should not be too much, but to be coated evenly. Coated, squeeze the adhesive, fixed with a rope, wipe the extruded glue, let it dry for 5 to 10 minutes, decoupled from the Government bundles. If the pen made of polystyrene plastic can be toluene, propylene ethyl acetate and other solvents bonding. Nine, other

When writing, you should pad some paper under the paper, in order to enhance the elasticity of the nib, reduce friction.

The nib should not write on metal and other hard materials to prevent damage to the nib.

The fountain pen should be cleaned every month or so, to keep the ink down smooth.

The fountain pen, if not used for a long time, should be washed and preserved.

Attachment: types of fountain pens

(1) gold pen: nibs with high gold content, the nib is softer, ......

Please ask why the fountain pen can suck ink

The fountain pen has a leather capsule containing ink, that is, you pinch the place where you suck ink.

When you squeeze the capsule, the air inside is expelled by the external pressure. Although the air is expelled from the bladder, the volume of the bladder is reduced by the squeeze, so the air pressure inside the bladder is equal to the external atmospheric pressure.

When you squeeze the pouch hand release, the volume of the pouch becomes larger, but the air inside is still so little, so at this time the pouch internal air pressure is less than the external atmospheric pressure, inside and outside the formation of air pressure difference. So at this time, the outside air very much want to go in.

But the only entrance to the capsule - the nib is immersed in ink, so the outside air on the ink to form a downward pressure. There's no way for the ink to get out, so it burrows into the relatively low-pressure pouch.

When the pressure of the ink inside counteracts the pressure of the air outside, there is no more ink in the bladder.

Rotary fountain pen how to suck ink

and ink absorber has nothing to do, one is not your pen is not used in the inverted, because so the ink will flow down, easy to appear such a problem, the second is the fountain pen itself, not enough to seal, so put there nib dry, the third reason is the ink, it is difficult to say.

Because different inks are not the same nature, some ink to the fountain pen, not much will flow, but write like a waterfall like the waterfall is very strong, and some of them to the fountain pen to go when the liquidity is very strong, the pen moves a little, the ink also move a little, but write not too out of water.

Then look at their own is not to use carbon ink, carbon ink is very easy to block the pen, so be sure to pay attention to try not to use carbon ink

So I suggest you still first observe which is the reason

can be so, first remove the carbon ink and the first and the case, change a better ink, see how, I use noodler I use noodler's Ink generally known as catfish ink ... Even if I don't write for a few months, the fountain pen is still watery... But now the market shortage of a bottle of nearly 100 yuan, depending on whether you want to spend the money .... Either use QUINK, Parker's ink, in addition to staining the hand is not easy to wash and especially easy to get on the hand... Other very good, put the pen is also a few months do not write the same a water, and very cheap, as long as a dozen dollars ....

In addition to the habit and the reason for the ink is the reason for the pen .... The only thing you can do is to change the pen.

After removing the habit and the ink, the reason is the pen.