Application of high temperature electric furnace

1. Natural air insulation, light and easy to carry. 2. The heating speed is 1 100℃ for about 30 minutes. 3. Both sides of the furnace are heated by radiation, and the temperature distribution is uniform. 4. Temperature control: PID automatically controls LED digital display. 5. Thermal insulation: imported high-temperature resistant ceramic cotton thermal insulation and ceramic plate and high-aluminum cotton triple thermal insulation. 6. Heater: KANTHAL heater imported from Sweden is durable, with stable temperature rise and fast heating speed. 7. The interior is made of high-temperature resistant ceramic plate, which is not easy to deform, and the exterior is made of galvanized high-temperature paint, which is beautiful and not easy to lose paint. Main indicators of high-temperature electric furnace: production mode: continuous production with atmosphere protection; heating mode: electric heating calcination product: powder service temperature: 60℃- 1700℃; temperature control accuracy: ≤ 1℃ Scope of application: high-temperature electric furnace is a national standard energy-saving periodic operation electric furnace, which is mainly used for normalizing, quenching and annealing of alloy steel products and various metal parts. Precautions for vacuum high temperature atmosphere furnace: 1. Don't stay in the high temperature furnace tube area except doing experiments. 2. When the experimental work is finished, if no one continues to use it, please turn off the special gas, keep N2 flowing, keep the furnace tube at standby temperature, and check whether there are other power supplies that should be turned off, such as clean lamps, acid boiling small electric furnaces or others, please turn them off at will. Please wear gloves when handling HF. If you accidentally come into contact with HF, please rinse it immediately, add 2% water to calcium gluconate, and rub the scratch 15'. 4, timely glass products, please be careful to use, so as not to break, causing serious cuts. 5. Avoid inhaling various gases discharged from the furnace or treatment tank. 6. Potassium cyanide (KCN) should not be mixed with acid, because they will produce highly toxic KCN gas. 7. Please inform relevant personnel (technicians, etc.). When you find anything that hinders safety, immediately. 8. Please save the amount of purified water. 9, wood chips, filter paper, cotton swabs, etc. Do not fall into the drain hole at the bottom of the cleaning tank to avoid water accumulation on the floor due to poor drainage. 10, the front ends of long and short push rods, please face upwards when not in use to avoid pollution. 1 1. When the wafer enters and exits the furnace, please accept the boat gripper and don't touch the furnace mouth to avoid polluting the furnace tube.