Gold foil pasting course

Glue: water = 2: 1 or 2: 0.5 or 2: 0 (for walls without latex paint and wood carving).

Pour in a little yellow paste (gilded with gold foil) or a little black paste (gilded with silver foil) and stir well with a stick.

Note: remember not to change water too much, which will lead to poor adhesion and bottom leakage after pasting.

2.

Roller brush glue

Brush the glue with wool roller or brown brush to the place where foil is needed. If the wool roller can't brush the place, it needs to be brushed with a combination brush or a brown brush. The joint can be protected by masking paper.

Note: It is best to roll the glue back and forth for 3 ~ 4 times with a wool roller and brush it back and forth for 2 ~ 3 times with a brown brush. Check whether there is any omission after rolling, and then brush the glue.

3.

pad pasting

Take disposable silicone gloves, remove the lining paper, grab the tin foil and stick it on the rubber brush, and then gently press it with the back of your hand.

Note: It is best to cover about one centimeter between foils to facilitate foil scanning.

4.

Foil pressing

Use a large or small curling iron to roll the foil in the direction of sticking the foil, so that the foil can be firmly stuck on the adhesive surface. If there is any glue leakage, stick it with tin foil and roll it up.

5.

Sweep foil

According to the specific position of the film, use a small brown brush with a combination brush to sweep away the excess film.

Note: sweep the foil lightly. If the force is too great, the foil surface will be imprinted. When sweeping the foil, it is best to sweep the foil round and round.

6.

Roller brush protective paint

Use a big or small curling iron to roll the pigment on the foil surface. It is best to roll the paint back and forth with a hair roller for 3 to 4 times, and dip the paint with a brush or wool brush before brushing. Try not to spray paint, it is easy to pollute.

Note: There are three varnish surfaces: bright, semi-matte and matte. Choose bright;

7.

sweep

Vacuum the lamp slot and the foil on the floor.