How to adjust the handbrake?

The process of hand brake tightening is as follows:

Tools/Materials: Changan Automobile, changan CS35, handbrake.

1, get into the back seat. Look at the picture. This is where the cup is put.

2. The plastic cup in the red circle is detachable. No screws. This is all embedded. Lift it with a little force and you can take it off.

3. When this storage box is taken away, find the handbrake line for adjusting the handbrake.

4. In this place shown below, this screw is the handbrake. Tighten it clockwise and loosen it counterclockwise.

Matters needing attention in adjusting handbrake

If the vehicle is still running when the handbrake is adjusted, the adjustment of the handbrake is unreliable. Because the wheel rotation will affect the tightness of the hand brake when the vehicle is running, the hand brake can not achieve the expected effect. Therefore, before adjusting the handbrake, make sure that the vehicle has stopped, the handbrake has been pulled up, and the wheels have completely stopped turning.

The tightness of the handbrake is the key to adjust the handbrake. If the handbrake is too tight, it will make it difficult to put it down, and the wheels will lock, causing the vehicle to be stuck; If the handbrake is too loose, it will cause the handbrake to fail, and the vehicle will still slide after parking, which poses a safety hazard. Therefore, when adjusting the handbrake, we must pay attention to the rationality of the handbrake tightness.