How to completely remove the label?

The way to completely remove the tag is to hold the belt buckle with one hand and pull the line with the other.

There will be a button on the label. When you find this buckle, hold it with one hand and gently pull the thread at the opening with the other hand. After finding the moving thread, hold the buckle with one hand and pull the moving thread with the other, so that the attention can be gradually increased from small to large, and the moving thread may be broken by direct force, so that the clothes tag can be completely removed.

If it's a disposable rubber buckle, you can't take it off after you plunge it in unless you cut it off. However, many of these plastic buckles are made of PP, which is relatively soft. You can carefully open the ring of rubber teeth with your nails to make the space larger than the size of your nails, so that you can take it out without damaging the label and then buckle it back in.

How to recover the broken clothes tag?

1, slot type

Trough tag is the most common tag in daily life. This label can directly unplug the plug from the connection of the label, and it is also very simple to install. On the contrary, it can be installed by directly inserting the plug into the slot. If the rope is broken, there is no way to recover it.

2. Glue needle

There are many kinds of glue needles, which are complicated to disassemble, so many people like to disassemble the glue needle tag by violent means. After disassembling it, they will find that if it is damaged, there is no way to reassemble it. Glue can be used at this time, which is to teach people to stick. When using glue, be careful not to use too much glue to avoid obvious sticky bumps after the glue dries.

3. Hemp rope type

Ma Chengxing is a type used by many leisure brands. This kind of tag is generally a relatively simple way to tie a knot, and it is also very simple to remove it. The installation is the same. Thread the thread from the tag until it is flush with the other end, then make a circle, and then use the rope head to thread it out of the circle and tighten it.