The process of weaving firecracker knot

Weaving firecracker knots is a traditional Chinese weaving craft, often used to weave bracelets, necklaces and other jewelry. Here is a simple tutorial on how to weave a firecracker knot:

Preparation: You will need a piece of thread about 1 meter in length and a thin stick (such as a pen, chopstick, etc.).

The first step is to fold the thread into two pieces, leaving a small loop in the center, place the small loop on the thin rod, and then wrap each end of the thread around the thin rod, up through the small loop, and then down through the loop.

In the second step, pull the threads at each end tightly together, take the thin rod out downward, and adjust the threads so that they make two equal-sized rings.

In the third step, pull out a section of the left side of the thread and thread it along the right side of the thread, through the bottom of the right ring, and then through the bottom of the left ring.

In the fourth step, pull a section of the right side thread out, run it in the direction of the left side thread, through the bottom of the left side loop, and then out at the bottom of the right side loop.

In step 5, pull the threads at each end tightly together and repeat steps 3 and 4 again until the weave is the desired length.

Finally, once the braiding is complete, finish braiding the firecracker knot by tying a knot in the thread at each end.

It is important to note that during the process of braiding the firecracker knot, the thread should be pulled tight to ensure that the braided firecracker knot is even and beautiful. It is also important to pay attention to the material and color of the thread, and choose the right thread and color for you to achieve the best results.