How to install driving recorder

Installation steps of driving recorder:

Tools: driving recorder.

1. Determine the best installation position of the driving recorder. It is recommended to install it on the right side of the rearview mirror in the car, as far as possible in the middle, so that the shooting angle will be corrected, which is more valuable for reference.

2. Determine the best wiring scheme according to the length of the power cord. It is recommended to simulate wiring first to determine whether the power cord is long enough.

3. After determining the installation position and wiring scheme of the driving recorder, the first step is to plug the power cord of the recorder into the gap on the roof.

4. After inserting the roof wire, it is necessary to pull down the door frame sealing strip, and then forcibly open the A-pillar decorative panel with both hands. Most of the A-pillar decorative panels are fixed with buckles, which will be tight for the first time. Don't be afraid to use some power.

5. The purpose of removing the A-pillar decorative plate is not to put the wires in the A-pillar, because many models have side air curtains for fear of affecting safety. Just to let the power cord pass smoothly, then insert the wire into the door frame sealing strip, aim at the A-pillar buckle, and gently knock the A-pillar decorative plate in with your fist.

6. From the upper end of A-pillar down to the door frame, while installing the sealing strip, insert the power cord into the sealing strip until the line is pulled out at the bottom of the instrument panel. At this time, it is time to measure the waist.

7. The power cord passes through the back of the glove box. According to the actual situation of different models, the cord can be fixed behind the glove box or hidden under the firewall or floor glue. Although this step is a bit troublesome, the visual effect will be the best.

8. In order not to see the how bright cable near the cigarette lighter, it is necessary to loosen the decorative plate screw at the bottom of the center console, make a small gap, insert the cable into the gap and then tighten the screw, but many models need to be flexible.

9. Plug in the power supply of the cigarette lighter, and after confirming that the driving recorder can be powered on normally, complete the installation and wiring.

Introduction of driving recorder

Driving recorder is an instrument to record the images and sounds of vehicles during driving. After installing the driving recorder, it can record the video images and sounds of the whole driving process of the car and provide evidence for traffic accidents.