Traditional Culture Encyclopedia - Traditional festivals - Is the leather pocket of the flat slingshot tied with crystal thread or amber belt?

Is the leather pocket of the flat slingshot tied with crystal thread or amber belt?

Each has its own advantages. The crystal thread is thin, and the tied rubber band head breaks faster than the amber belt because of repeated friction with the crystal thread. Amber ribbon is a new thing, not as abrasive as crystal thread. However, the rubber band of amber thread system is not strong, and the position of the rubber band may be loose, easy to pull off and out of the leather pocket.

How to tie the slingshot rubber band? (traditional slingshot)

Tools/raw materials

Rubber band

rule

scissors

Thin steel wire (spring, umbrella frame, secondary key ring, etc.). Can be used)

ball pen

Pidou

Steps:

First, measure two 28cm long rubber bands with a ruler, cut them with scissors, then mark the distance from each rubber band to the head 1cm with a pen, then cut four rubber bands 1mm long to make binding strips, and fold the steel wire in half to make a "8-character set".

2. First, put the tie rod of 1mm on the figure of 8, and then insert the long rubber band into the triangle formed by the figure of 8 and the tie rod.

3. Pull the "8-shaped sleeve" with all your strength, and let the pull rod cover the rubber band.

4. Use the "8-shaped sleeve" to penetrate the tie bar.

5. Hold the rubber band with one hand and the figure-eight sleeve with the other hand, and rotate the figure-eight sleeve by 180 degrees.

6. Stuff one end of the rubber band into the "8-character set"

7. Grab the "8-character set" with one hand and the rubber band with the other hand, and tie the rubber band.

8. Repeat the above method, and tie all four ends of two rubber bands with tie rods.

9. Insert one end of one rubber band into the hole on the edge of the leather bag, and then insert the "8-shaped sleeve" into the binding belt.

10. Insert the head of the rubber band into the "8-shaped sleeve", hold the rubber band with one hand and tie it with the other hand, and pull it hard.

1 1. Put the tied rubber band on the ear of the slingshot, and pull it with the rubber band, and the rubber band will be put in the ear.