How to wind a spinning wheel

The winding method of the spinning wheel is as follows:

1. Install the reel with fishing line on the fishing rod and unscrew the wheel seat of the fishing rod. Insert the wheel foot into the wheel seat, and finally close or tighten the wheel seat. It should be noted that the reel must be tightly wound on the fishing rod, otherwise the fishing boat will be accidentally thrown out when throwing the line hard. After installing the wheel, try to shake the reel up and down by hand to see if the reel is installed firmly.

2. Adjust the decompression knob. The release knob is a device for adjusting the force on the reel. The adjustment of unloading force is based on the fishing force of fishing line. For example, the tension of the fishing line is 3kg, which can be hung at the end of the line, and then a weight of 1.5- 1.8kg can be hung at the end of the line. At this time, the fishing rod and fishing line are vertical, and the reel can automatically pay off the line.

3. When swinging the lever, the left hand should be pressed downward and backward appropriately. When the bait is thrown from back to front, the right hand will release the line pressing finger and throw the fishing rod forward. When the bait flies out, the tip of the fishing rod still faces somewhere. When the bait and plumb hammer completely fall into the fishing point, pause for a while, then manually adjust the line stop to reset, tighten the excess fishing line, and finally fix the fishing line.

The winding method of spinning wheel is to rotate the moving frame upwards, tie the thread end of fishing line on the silk cup, then put down the frame and shake the handle to wind the fishing line on the silk cup. It is especially important to note that no matter how thick the thread is, it should be slightly lower than the clearance of the thread cup, which can effectively avoid thread disorder.