How to remove the bucket of washing machine

1. To disassemble the whole workbench, there must be 2 to 4 screws. Unscrew them as shown in the figure below.

2. How to remove the washing machine bucket Some washing machine screws may be behind. You can lift the front to tilt it, or find someone to hold it, as shown in the figure below.

3. How to disassemble the washing machine bucket is mainly because the power cord at the back must not be damaged. After loosening the screw, push it forward slightly and the panel will be taken out.

4. How to disassemble the washing machine bucket with a big screwdriver, unscrew the screw and take out the impeller. There is a gasket under the impeller, so don't lose it.

5. Remove a big nut from the washing machine barrel. It is recommended to find a special tool and tighten it when putting it back, as shown in the following figure.

6. There is an L-shaped fixing plate under the washing machine bucket. After taking it off, you can take out the whole barrel, as shown in the figure below.

Extended data:

Matters needing attention in the use of washing machine

1. Avoid sediment, waste water and sundries: sand entering the shaft seal will wear the shaft and shaft seal and cause water leakage. If clothes are soaked in the washing machine for a long time, water will accumulate in the machine for a long time, which will affect the service life.

2. Avoid excessive: No matter what clothes you wash, you can't exceed the rated amount to avoid overloading and damaging the motor.

3. Avoid using too much or too little water: excessive overflow will affect the safety and service life of the machine; Too little will affect the washing effect and increase the wear of clothes. The water temperature should not be too high. When draining water, add cold water first, and then heat the water. Generally, the water temperature is below 40℃, because high temperature is unfavorable to some synthetic materials in the machine.

4. Don't press two buttons at the same time, and don't turn the timer in the opposite direction.

5. Avoid stabbing the blocked part of the drain pipe with hard objects.

6. Avoid grounding the power socket: Because the working environment of the washing machine is humid and prone to leakage, grounding the power socket can avoid electric shock accidents.

7. Avoid idling of the power supply to avoid damaging the oil seal. If idling is needed, you can turn the impeller by hand.

8. Avoid covering with airtight articles such as plastic film, and avoid exposure in the scorching sun.