Weaving method of coarse wool hat in weaving process

The teaching method of coarse wool hat knitting is as follows:

Preparation materials: ruler, stick needle, wool and soft ruler.

1. Measure the head circumference of the person who wants to wear a hat with a soft ruler. Take 26cm as an example.

2. Number of stitches from ten stitches on the sticking needle (take ten stitches as an integer to facilitate subsequent calculation, and stitch can be started according to personal preference).

3. Then knit with a knitting needle for 7- 10 rows continuously until a certain length can be measured.

4. Measure the width of the fabric with a ruler, and divide the number by the number of stitches to get the width of one stitch of wool, as shown in figure 10, with the width of ten stitches being 4.2cm, that is, the width of one stitch being 0.42cm.

5. Then according to the measured head circumference width of 26cm, it can be calculated that 62 stitches are needed.

6. After picking up the needle, we began to knit the edge of the hat. We knitted a stitch for the top and a stitch for the bottom. Weave to the required length.

7. After picking up the needle, we began to knit the edge of the hat. We knitted a stitch for the top and a stitch for the bottom. Weave to the required length.

8, and then began to change the needle method, knitting 6 needles, 6 needles on the needle, and 6 needles on the needle, a group of ***8, issued 48 needles. Then start knitting 6 stitches, up and down 6 stitches, and weave 10- 12 rows.

9. Then start twisting the needle. Twisting method: when you put the needle down, you start to twist the needle. The first three needles are selected on the toothpick, the last three needles are woven first, and then the selected three needles are woven.

10. After twisting, continue to knit with 6 stitches and 6 stitches until the row of 10- 12. Weave to the required length.

1 1, and then start to reduce the needle. Needle reduction method: knit one needle to lower the needle, then repeat two needles and one needle to complete the first lap, and then knit one lap to lower the needle.

12. According to this needle reduction method, the needle is reduced three times in a row, and there are still 12 turns on the stick needle. Then leave a 20 cm thread, thread the wool into the loop, and then tie it tightly on the reverse side.

13, then turn it over and tidy it up, so that the new wool hat is knitted.