How to choose a good fishing rod

1. Classification: There are two kinds of rods: parallel rods, also called insertion rods, vibrating rods, and also called extraction rods.

Second, tonality; Generally, platform fishing rods are divided into three types: soft fishing rods, hard fishing rods and superhard fishing rods, commonly known as 46, 37 and 28, and superhard fishing rod (28) is the most commonly used in platform fishing.

How to choose? We pull out the new rod, one person holds the rod tip, the other person holds the rod handle, and then lift the rod with a little force to check the position of the main bending point of the rod. If the length from the bending point to the tip of the pole is two-tenths of the total length of the pole, then the pole is super hard fishing, that is, two or eight poles, and so on. Because there is not much difference in quality between domestic and imported fishing rods, and most of the fishing rods on the market are joint ventures, it is recommended to buy ultra-hard fishing rods no matter where you fish. Because the super-hard fishing rod has obvious fast reaction speed, high fishing rate and convenient fishing, it will not be difficult to carry ashore because the rod is soft, and the number of knots is small and light.

Third, the process: first look at the appearance of the pole, the smoothness of the paint surface, whether there are spots, the bonding between the tip of the pole and the flexible cord joint is not good, and the joints between each section of the pole and the previous section are uneven. Check whether there are cracks at both ends of each pole and whether the pipe wall is uniform. If necessary, check the length of the embedded joint of each electrode (vibration type) again, 20-40 mm.

4. Centripetal force: Let's make a comparison between two poles with the same weight. After the new pole is pulled out, hold the pole handle in hand, make a fish action upwards and lift the pole. When the pole is raised horizontally by more than 60 degrees, feel whether the handle weight of the pole is in the middle of the pole or retracted into the palm. A rod whose weight returns to the palm of your hand is a good rod, otherwise it will feel heavier and heavier when fishing.

5. Soft and hard: When shaking the pole up and down at a uniform speed, more than 40% of the pole tip should not be too soft, and the bad pole tip will bounce irregularly like a left and right or like a snake. A good pole just bounces in the direction of shaking.

6. Uniform stress: imitate the action of lifting fish and pole. One person holds the pole tip, and the other person lifts the pole hard to see if the bending radian of the pole is even. If there is an obvious folding point from the tip of the pole to the end of the pole, then the pole is problematic and easy to break.

7. Price: Everyone knows the necessary conditions for buying poles.

It is very important to pay attention to the cost performance when selecting the pole. If you want to buy a light, strong, thin and low-priced pole, there may not be so many good things in the world. Rods with good quality and workmanship are generally more expensive. Listen more at ordinary times, watch more when choosing, and try to buy the fishing rod that you think is most satisfactory with the least money. It depends on your understanding of the pole and your skill in choosing the pole.

Because pole selection is actually a very delicate job. 1, depending on whether the pole is straight or not. Of course, because the gravity of the pole itself will bend a little.

2. It depends on whether the paint of the pole is uniform, which is related to the service life in the future. Choose the tonality of the pole according to the kind of fishing you want. The jointing rod can carry a weight of 0.8 kg (mineral water bottle, etc.). ) and hang heavy objects on the pole (don't let others help you hold the pole, because then you won't know how hard he works). Looking at the bending degree of the pole, if the distance from the pole tip to the highest point of the bending radian is about 1 of the whole pole length, then we say that the pole is at the second octave. It is more suitable for fishing a little bigger fish. Similarly, if the distance from the tip of the pole to the highest point of the bending arc is about 65438+3/00 of the total length of the pole, we say that the pole is in the tune of Sanqi, which is more suitable for fishing than the pole with the tune of 28. By analogy, generally no one will use the five-five key.

3. Check the insertion amount of the electrode. Open the handle of the pole and check the insertion amount of each section of the pole after pulling out the pole. Preferably 5 cm or more.

Finally, don't look at what is written on the pole. It's useless, because if you fish often, you must know that the pole can't blindly pursue hard, hard is brittle, and a big fish is easy to break later. As for the weight of carbon rods, the weight of 3.6 meters generally does not exceed 100G. 4.5 Generally, it shall not exceed 130G. 5.4 Generally, it shall not exceed 180G. Of course, this is only an indicator, and it doesn't need to be deliberately pointed out. Just to tell you, carbon is extremely light.

That's how I chose the fishing rod. I buy fishing rods instead of pursuing brands, because the more famous brands are counterfeited, the easier it is to be fooled. That's how I chose the fishing rod.

1, the price is determined according to the economic strength, and the length is determined according to the use of soft and hard.

2. First, pull out the fishing rod from the tip and observe whether the joint fits well. If the gap between the two rods is greater than 0.2 mm, it can be considered. Don't buy it if it is larger than 0.5 mm

3, gently shake the fishing rod, feel whether the fishing rod body shakes evenly, if you feel that the fishing rod is abnormal, don't buy it.

4. First observe the appearance of the fishing rod, whether there is trauma in the paint and whether the rod body is vertical, and then disassemble each section of the fishing rod to observe whether each section is smooth and whether there are cracks at both ends. If it is cracked or not smooth, don't buy it.

5. Insert the upper ends of the two connecting rods into the upper ends and check the remaining length. Generally speaking, the last section should be about 40 mm, the last section should be about 25 mm, and the rest should decrease from bottom to tip. If the difference is too big, don't buy a section.

6. When buying a straw, bring a wire board. When choosing a straw, connect it to the fishing rod, and hook the weight of more than half a catty at the other end to observe whether the fishing rod is evenly stressed.

We can start from the following aspects: 1. When buying a FRP fishing rod, pull it out and stretch it one by one to see if the fishing rod is straight (the straighter the better), and the top grade is not crooked;

See if the paint on the fishing rod is bright and tidy; Whether the joints are tight and seamless, you can hold the tail of the pole with both hands and shake it up, down, left and right a few times. If you feel a "plop", it means that the joints are not well matched.

2. Measure whether the actual length of fishing rod meets the standard, and the smaller the error, the better. Unscrew the back cover and observe whether the thickness of each annular horizontal tube wall lamp is consistent and whether there are cracks. If you buy a carbon fishing rod, in addition to the above three steps, you need to remove each section.

Observe whether the inner wall glows under the light. The inner wall of a good rod shines like a gun bore.