Traditional Culture Encyclopedia - Traditional festivals - How to introduce the causes of uneven tiles?
How to introduce the causes of uneven tiles?
First, what should I do if the tiles are uneven?
1. The solidified cement is not dry; The situation is relatively simple. Only the decoration master tapped the floor tile with a wall knife until it was flush with other bricks.
2. The solidified cement has dried; This situation is more complicated. If a few bricks are uneven, use tools to remove the uneven floor tiles and replace them with new ones. After the batch of putty is brushed, it will be solidified with other cement.
3. If the floor tile is uneven in a large area. Suggest redoing everything. In order to avoid foot injuries when walking in the future.
4. If it is a small area. Then the uneven bricks need to be reworked. Free rework. If so, you need to buy new floor tiles and re-lay them.
Second, the reasons for uneven tiles
1. There is something wrong with the tile itself.
Tile arch back
Uneven tiles will have a fragile arch back due to high temperature firing. In fact, each tile is not absolutely flat, and the center is arched to a certain extent. Even if there is an error in the exact machine, it cannot be avoided. Usually, this weak arch will not affect the paving results. If the arch back exceeds the standard limit, paving will stop. Otherwise, after paving, the middle part of the tiles bulges seriously, and even a "small ditch" is formed between the tiles, and the workpiece must be turned over.
Tile warping
Tile inclination angle is also called floor deformation, mainly because the tiles are not burnt out. Ceramic tile formula uses high-temperature materials, and manufacturers add low-temperature materials to burn quickly. In the firing process, the fired low-temperature materials surround the high-temperature materials, forming vitrification on the surface, while the internal materials are not completely vitrified or vitrified. So after laying, due to the tension of cement and environment, the rebound deformation has a warping angle.
2. Environmental reasons
(1) foundation deformation
The captain said that due to geological problems, the building will have a certain degree of settlement. Different positions, different forces and uneven settlement. After a long time, the ground will be uneven and the tiles will be uneven. This is the so-called disadvantage.
(2) Temperature
The so-called daytime is the influence of temperature. When the temperature is too low or too high, the temperature difference changes greatly, which will lead to the deformation of ceramic tiles. In the north of winter, the temperature in the north is too low. The moisture in cement mortar binder will freeze and expand, destroying the structure and strength of cement mortar. In this case, the tile will become convex. Ceramic tiles will be deformed if they are heated for a long time.
3. man-made
Incorrect proportion of cement mortar
Traditional pavement usually uses cement and sand as binder, and the ratio of cement and sand is very important. Improper proportion, too high proportion of sand, or no adhesive is added to the mortar, all of which will make the cement mortar stick to the tile and the tile turn up.
The above is the introduction of uneven tiles that we have brought to you.
- Previous article:What do you think is the difficulty in breaking "996"?
- Next article:Is smart watch good or traditional?
- Related articles
- What brand of jeans is good?
- This man proposed monogamy, but he married six beautiful wives and a girl in her sixties 18.
- What is an intelligent smoke detector and what is the difference between it and ordinary smoke detectors?
- How big is the main line of eating lead 1.4 float?
- What about Guangzhou Bao Hua Glass Products Co., Ltd.?
- Take a nice Spanish name ~
- Less utilitarian pursuit, more unreasonable persistence.
- An example of the application of curriculum gamification in early childhood education
- A man in Yunnan spent seven years carving a work and inheriting his hometown craft. What level is he?
- What are the assembly methods of hooks?