The most complicated way to make a cabin in my world?

Results

The same starts with this cabin

Extend out two beams on both sides of the cabin, extend out about 2-4 frames in length

Build four pillars with spruce at each of the four corners of the beams

Go to the roof, and use spruce to build four small pillars on the roof, about 2/5 in height from the big pillar and about 2/5 in length from the beam

At the very top of the small beam, use spruce again to create 4 smaller pillars on the roof, about 2/5 of the height of the big pillar, and 2/5 of the length from the beam

At the top of the small beams, use spruce to extend 2-4 squares outward

Use

stone and half-bricks

To build an eave of the roof

As in the picture above

And then, fill it up with the stone and half-bricks

Fill it up in the same way as the above, and you should pay attention to the fact that when filling it up, you should use spruce to fill it up. Note that you need to destroy the area circled in red in the picture below

Then fill the gap between the roof and the main room below with snow blocks, at this point, if it is normal, there will be traces of snow on top of the roof, so please use the

Raw stone half-bricks to fill it in

Next, you can use the stone half-bricks to connect the four corners of the big columns

. Note 1. just do it at the front and the back

2. to have the top and bottom divisions as shown above

Please fill them in

Then on top of 11

continue to extend the wall outward on the left side about 1/4 of the length of the side and make a grid of small eaves

fitting the door as in 6.7 and use the inferno grill for the window. At this point you'll realize that the wall is 2 layers thick, so not only is there an outermost wall for windows, but there's also an interior wall for decorations.