Traditional Culture Encyclopedia - Traditional festivals - Solution of drift adjustment method

Solution of drift adjustment method

The bleaching method is as follows:

First, find the bottom first:

Wrap the lead leather seat with enough weight to ensure that the lead weight lies flat on the bottom of the water after the fishing group enters the water. It is required that the number of eyes exposed by the float should not be too much to ensure that the waterline is vertically straightened and the water depth measurement is more accurate, as shown in the following figure.

After reaching this state, you can adjust the floating without any worries. At this time, you can soak the fishing group and float in the water. This is because both the fishing group and the float often enter the water, which will affect the change of the weight of the fishing group. It will be more accurate to soak for a while and then adjust the float. We can bait first. Get ready.

Second, the tone:

The next step is to pull down the float seat and determine the half water depth to adjust the float. Generally, the floating seat is clamped by two space beans, and the top one can be fixed at the position where the bottom has just been found, so that it will be much faster to find the bottom accurately in the back.

The float seat is pulled down by about 2 times the length of the auxiliary line, and it is more accurate to adjust the float at this depth, especially when fishing in deep water. Let's take Siyao as an example, trim the lead skin with an empty hook and half water until four eyes float out of the water. Trimming lead skin is a patient job. When the float begins to slowly sink into the water, the lead skin needs a little trimming.

Third, weigh the bait:

To adjust the eyes, it is not to hang the bait directly to find the bottom, but to look at the weight of the double bait to determine the fishing eyes. Assuming that the weight of double bait is 2 meshes, it means that one bait is 1 mesh. Of course, there is often no such coincidence in actual fishing, and the weight of the double bait may be greater than or less than 2 meshes.

If the weight of the double bait is more than two eyes, or even the floating tail no longer comes out of the water, it is ok to fish the bottom normally, but the state is that both baits are at the end. Or suppose it happens to be 2 orders. According to the formula of fishing order = adjustment order-bait weight, fishing order 2 is the most spiritual fishing order at the bottom of fish and also a floating fishing order.

Fourth, find the bottom accurately:

The key to finding the bottom accurately is to use bait, not heavy objects. Many fishermen like to find the bottom with heavy objects, thinking it is more convenient, but this is not right. The weight of the weight is different from that of the bait. Finding the bottom with heavy objects doesn't mean that the bait can catch this number.

Adjust the four catches and two catches when rubbing the bait. Grasp the bottom normally and replace it with earthworms. You will find that earthworms are not at the end, so they are used for heavy objects and actual bait. Hang double bait to find the bottom and pull up the floating seat. At first, fixing the space beans will work, or pulling up the sub-line with twice the length, and the distance will be very close. According to the formula, the bait starts to touch the bottom when the fishing eye reaches 2, so the bottom is found.

Five, find a mouth:

After finding the bottom, I started fishing. The double bait state in the above picture is very clever, which is the most spiritual state of fishing bottom, so the fish rate in wild fishing is often not high. When looking for a mouth, it is often necessary to look into it, which requires pulling up the floating seat and letting out the long waterline. We know that the weight of a single bait is 1 mesh, which is the initial assumption.

When the fishing net reaches 3 meshes, it shows that only one bait has played a floating role, and on the other hand, the baiting is completely completed. When the fishing net reaches 4 meshes, the weight of the double bait has no pulling force on the float, and the double bait will lie at the bottom.