In the renovation Tiling procedures and laying methods

We are in the new house decoration, laying tiles is one of the extremely important step, tiling procedures is very critical, laying methods are mainly two types: one is the dry paving method, the other is the wet paving method. Below we will specifically talk about tiling procedures and laying methods.

Mix sand and cement in the ratio of 3:1, then add a small amount of water to mix the cement and sand into a consistency that can be mixed by hand, and mix them together. Then mix a thick tub of cement slurry to use. Pour the water in before laying the tiles. Start tiling from the top down, shoveling cement and sand into the areas you want to tile. Once the tiling is complete, use a small trowel to initially level. Then use a small board to smooth the surface, then the back of the tile is coated with a thicker cement slurry, then carefully place the glued tiles where you want to lay them, paying attention to the joints. Then use a small rubber mallet to tap the solid and level. This is the most critical step in the pasted tiles procedure steps

1, pasted tiles procedure in the dry paving method is to mix the sand and cement in the ratio of 3:1, and then add a small amount of water to mix the cement and sand into a consistency that can be mixed by hand. Spread the sand-cement mix on the floor and level the surface with a flat surface. Apply a very thick layer of cement to the back of the tiles, place the tiles on the floor and finish with a rubber mallet. It is mainly used for laying floor tiles. Dry-laying requires a high level of skill on the part of the tiler, and the mortar is thick and costly. However, dry paving floor tiles are horizontal, not easy to deform, not easy to dig out, the effect is good.

2, The procedure of tiling in the wet paving method is to mix sand and cement in the ratio of 2:1 then mixed with water, the amount of water is more, so the viscosity of sand and cement is higher. It is then applied to the back of the tiles that have been soaked in water. The main application of wet paving is with walls. Due to the high water content in the mortar and the evaporation of water during the solidification process, the wet molding method is prone to produce some small air bubbles, resulting in gaps between the tiles and the mortar, leading to the phenomenon of hollow drums.

This is the paste tile procedure and laying method, can help you?

Tuba Rabbit online free for everyone to provide "each decoration offer, 1-4 local decoration company, 3 sets of decoration design scheme", as well as decoration to avoid pit strategy! Click on this link:/yezhu/zxbj-cszy.php?to8to_from=seo_zhidao_m_jiare&wb, you can get free Oh~