How to drift carp fishing!

We all know that carp is a bottom fish. When fishing carp, the bait should sink to the bottom, usually to the bottom (that is, lower the fishing height or adjust the spirit to the bottom), so that even if the bait melts, the hook is still buried in the bait. Today, I will talk about how to adjust the drift of carp fishing from three aspects: Lington and drift selection, with a drift chart.

First, the situation of blunt fishing.

The feeding mouth of carp is inhaled from top to bottom, and the bait is often suspended. Most of the fish in carp are black, and the buoy marks are obvious. Therefore, it is generally not necessary to adjust more fishing (such as "adjusting 4 to catch 2"), but to adjust less fishing (such as "adjusting 4 to catch 4" and "adjusting 5 to catch 5") or to adjust less fishing, so as to take care of crucian carp. Fishing a few times, regardless of the weight of the bait, one hook undercover, one hook touches the bottom, recommended.

Some fishermen use "adjust 2 to catch 2", and the bottom of the water is uneven at night. Sometimes they catch one eye, sometimes they catch three eyes, which is no problem.

In the case of many small miscellaneous fish, it is also good to put the water flat and catch two eyes.

It is ok to fish carp in the wild or catch 4567 with one or two eyes, because the length of the secondary line is more than 30 cm, which is not afraid of lead sinking and can effectively filter out some messy signals. Not if it's in a black pit, where the fish are usually slippery and hurt, and their mouths are very light. At this time, it is necessary to adjust the drift, increase the hook distance and reduce the drift and hook number according to the actual situation, instead of simply adjusting it several times.

Second, the situation of spiritual fishing.

However, in some fishing videos, they are usually high notes, basically 5 ~ 9 singles. The reasons are as follows: fine tail bleaching is basically used now, and a rubbing bait can press down 8 or 9 meshes; Even if you adjust 9 to catch 2 ~ 3 meshes or 3 ~ 4 meshes, the bait is still in a dull state. This is related to the hook weight, bait weight, drift size and even the weight of the sub-line. Another example is "adjust 4 and grab 2". If the weight of the double hook and the double bait is only 2 meshes, the double bait for catching 2 meshes is still in half water. If the weight of the double hook and the double bait is 4 meshes, it is possible to catch 2 meshes and both baits are undercover, and the sub-line is very curved.

However, in the waters with thick silt at the bottom of the water, the bait just touches the bottom when fishing. For example, when "adjusting 4 to catch 2" to hang small bait, two hooks hang on the bottom of the water, and one hook touches the bottom; Some fishermen even "catch two out of ten", but when fishing is dull, it is easy for the bait to get stuck in the mud and the fish can't find it.

When the density of carp is high or the opening is good, the fishing height can also be increased and decreased. However, if you use it when fishing carp in the wild, the carp may still wander around and the bait may have fallen off.

Third, selection and bleaching.

The choice of floats should also be based on the weight and size of the bait. If you don't understand, start from 5 to 2. Carp fishing often uses big bait, so the double bait can generally hit the end, and then slowly adjust according to the situation, that is, increase the number of fishing eyes until you catch carp.

In short, try according to the actual situation, and other people's methods may not be effective here.