Correct connection of sound card mixer

The mixer is connected to the sound card, and the specific operation is as follows:

1, general mixer has main output, grouping output, AUX auxiliary output, etc. (Note that some outputs cannot output all mixer inputs). After selecting one, connect it to the recording device with a cable (or jumper).

2. Set the corresponding selected output switch, volume knob or fader on the input channel of the mixer to the correct position (some mixers have many buttons, please pay attention to whether there are too many mute, 2TK, high and low knobs, left and right channel settings, etc.).

3. Before recording, use recording software to monitor the appropriate volume. Check the control interface of the sound card. When playing sound, check whether the input volume column indicates, yes, software problem, no, and then check (two aspects: 1 no input, 2 sound card is broken).

4. Look at the volume indicator bar output by the mixer, or connect the speakers directly. If yes, check the line change of 1, if not, check the mixer setting problem, input source problem, etc. (If it is too much, push back or forward).

5. Macintosh mixer, the imaginary power supply of the mixer should be turned on, and the output of the mixer should be connected to 1/2 or 3/4 of the sound card. If you connect 1/2, be careful to use line instead of mic, otherwise the noise will be louder.