What is the installation method of hot and cold faucet hose? What are the general principles for installing hot and cold faucet hoses?

It's winter now, and the weather is getting colder every day. It's unbearable cold. It would be great if you turn on the tap and have hot water when you get home! What's so hard about that? Nowadays, many families have installed hot and cold faucets, so cold water and hot water can be switched at will, and cold water stimulation is no longer needed in the cold. But do you know how to install hot and cold faucet hoses? If you want to have both cold water and hot water pipes, you certainly need to install special water pipes. The following small series will introduce you to the installation method of hot and cold faucet hoses. Come and have a look!

Installation method of hot and cold faucet hose

1 Close the main water valve first.

2 Find out the faulty hose connector on the water inlet pipe and unscrew it.

3 Then remove the faucet. Faucets are usually fixed on the washbasin or washbasin with screws. Find the retaining nut and press it. Then the other end of the broken hose can be unscrewed very loosely.

Screw on the small end of the new hose without winding the sealing tape. I asked the merchant, and I didn't tie it myself, so I didn't miss it. Fix with pliers.

5 Install the faucet in the reverse order of disassembly. Put the panel, etc. In position.

Screw one end of a new hose onto the water inlet pipe with a nut, and do not wind the sealing tape. Fix with pliers. It doesn't matter.

The installation of hot and cold water pipes generally follows the following principles:

1, for the installation of hot and cold water pipes in the bathroom, the water pipes usually can't reach the top of the ground, and the pipes should be laid straight to avoid bending. The layout should be safe and reasonable, as far away from the circuit as possible.

2. The hot and cold water pipes in the bathroom should be separated, not too close. Hot and cold water outlets must be kept horizontal, generally hot on the left and cold on the right; The height of shower pipe is between 1.8m and 2.1m.

3. The position of the pipe clamp and the slope of the pipeline shall meet the specification requirements. All kinds of valves should be installed in the correct position and kept stable, which is convenient for use and maintenance.

4, hot and cold water pipes are generally into the wall, carefully check the depth of the slot when slotting, hot and cold water pipes can not be in the same slot.

5. When installing the water inlet and outlet of the water heater, the positions of the water inlet valve and the air inlet valve must be considered and installed in the corresponding positions.

The above is the installation method of hot and cold faucet hoses and the principles that should be followed in the installation of hot and cold water pipes brought to you by Bian Xiao. Well, after reading Bian Xiao's introduction, do you know anything about the installation method of hot and cold faucet hoses and the principles that should be followed in the installation of hot and cold water pipes? Bian Xiao thinks it is a very important step to install hot and cold faucet hoses, because the faucet hoses can be used normally. But if you can't install it, it's better to ask professionals to operate it!