9 square meters 4 meters high jump basement how to design compartmentalization

Many homeowners home basement height is very high, there are more than 5.7 meters, if you do not do compartmentalization, it is too much of a waste of space on the fa?ade, partitioned into two floors, you can also store more items. Then how to partition the basement into two floors? How is the effect of the basement compartmentalized structure? We look at the relevant introduction.

How to partition the basement into two floors?

1, the basement to do two layers can be separated by partition. You can use pine boards, movable board room with the kind of on the line, about two centimeters thick, but you have to lay a dense point of sub-beam, and this board sound insulation is not very good, the following can be done a ceiling, depending on what you have to use. Many families of the basement and attic height of 4-5 meters or so, do a layer of height is too wasteful, usually do a compartment, increase the use of area.

2, the normal basement compartment practice is to pour concrete compartment, but the concrete needs to be tied reinforcing bars, standing template, pouring concrete, in the basement, these processes are complex and cut is not easy to implement, the steel structure compartment is a good solution to these problems, saving construction time, and relative to the concrete compartment at a lower cost.

3, construction time to ensure that the following layer of height 2.6 meters, the thickness of the steel structure 0.15 meters, steel structure above the floor layer of 0.04 meters, so that the height of the upper layer of 2.5 meters, excluding lamps and lanterns and ceiling thickness of 0.15 to 0.2 meters, so that the above layer of net height of 2.3 meters. The lamps on the lower floor are all installed inside the steel frame structure, and the ceiling is installed directly on top of the steel frame structure, so that the net height of the lower floor is about 2.58 meters. The partition walls are all made of fireproof boards, and fresh air is introduced and forced-exhaust facilities are added, and so on. Safety first, other according to the norms is done, pay attention to the secondary structure of the stability of the layer height and fire and so on. Pay attention to ventilation and air permeability, do not fall off the roof, do not use plywood trim, use fire-resistant materials. The simpler the better, pay attention to waterproof safety, ventilation and water, electricity and gas.

4, with cement nails in the basement on both sides of the symmetrical height position nail square wood bars, nail a few layers of their own to see the need. Xu carpentry boards built on the square wood strips to form a compartment. Store items on the compartment to save space.

5, high room partition usually have two practices. One is cast-in-place panels and one is steel and wood construction. Pick high-rise houses are basically in accordance with the steel structure design, cast-in-place slabs have a large self-weight, will cause uneven subsidence of the foundation, so that the house cracking, is not allowed. Another method is steel and wood structure. In general, the use of channel steel on the line, but with I-beam bending strength will be higher, of course, the cost will be higher. The advantage of steel and wood structure is that the speed is fast that is built that is used do not need to wait ...... Click to view the full article