How to assemble hangers

How to install the hanger is as follows:

1. During installation, after drilling, assemble the expansion screws with the four pulley brackets respectively. After assembly, two double pulley frames and two single pulley frames are respectively installed on the drilling hole.

2. When installing, assemble the corner device with expansion screws. This method is very important to determine the installation position of the corner device. The position of the turning device must be perpendicular to the position of the crank, that is, 90 degrees. After determining the installation position, mark and punch holes, and install the assembled corner device.

3, can't ignore the two ends of the wire rope through one of the double pulley frame, the other end all pulled through the corner device, everyone's attention method. The operation of the other wire rope is the same as before, and then the button at one end of the wire rope shaken by the hand crank is hung at the end of the wire rope of the angle changer, and the operation of the other wire rope is the same as before. Install the fixing cover.

What should I pay special attention to when installing hangers?

1, using the installation template, measure the size of the balcony installation position to determine the installation position, and mark the qualified screw hole position.

2. Drill four expansion screw holes with an impact drill. The depth of the expansion screw hole is generally about 4-5 cm. Drive the expansion screw into the hole, loosen the screw so that the distance between the washer and the nut is about 5 mm, and then remove the nut at the other end.

3. Remove the end caps at both ends, carefully lift the main engine, and insert one end of the main engine on the gaskets of the two expansion screws. At this time, you should first connect the power cord; Brown ground wire, blue ground wire and yellow-green ground wire; Then wrap it with insulating tape and put it in the gap between the mainframe and the ceiling.