How to install underfloor heating leveling specific construction process specification for underfloor heating leveling

Traditional underfloor heating is usually referred to as water underfloor heating and electric underfloor heating. This type of underfloor heating after leveling, the general overall thickness will be about 7-8cm. Thin floor heating is still water floor heating, but with the traditional water floor heating is not the same, it is relatively simple to lay, directly with the groove of the insulation board for the fixing of the floor heating pipe, generally do not need cement for leveling, so the layer height is generally only 3-5cm. in order not to cause indoor oppression, the installation of floor heating requires the room height of not less than 2.67m, in which the room is less than 2.8m for the user, it is recommended that the installation of Thin floor heating, room height above 3m, you do not have to worry about the problem of floor heating leveling thickness. If your room height is lower than 2.67m, you can choose the way of heating radiators.

Floor heating leveling is generally most likely to frequently appear two aspects of the problem: sand or cracks, sand is generally not enough strength of the concrete floor caused by, that is to say, perhaps a little too much fine sand, can be changed to sand, or the cement used by the standard number of the insufficient (this phenomenon is more common) caused by everyone in the backfill layer of the ratio of the attention to be on the line.