How to install aerator water lobe oil seal

The steps for installing the aerator water lobe oil seal are as follows:

1.Cleaning: first clean the surfaces of the impeller, bearings and journals to ensure that the surfaces are clean.

2. Coating grease: Coat a small amount of lubricating oil or grease on the contact surface of the impeller journal and oil seal to keep the oil seal sensitive.

3. Installation of oil seal: Install the oil seal on the impeller in the correct direction, make sure that the oil seal is installed smoothly and there should be no offset.

4. Fix the oil seal: use the locking case to install the oil seal, use the force evenly, do not overdo it, excessive pressure damage to the oil seal, set up to ensure that the installation point will not produce leakage of the seal.

5. Inspection: After the installation is completed, check whether the installation of the oil seal is smooth, whether the seal is sealed.

When installing the oil seal, you need to pay attention to the direction of the oil seal, do not make the oil seal deformed or damaged during the installation process. If there is any problem, it is recommended to consult a professional engineer for repair or installation.