How to adjust the drift of single hook

Lead fishing is similar to the principle of living drop of a sea pole and bottom drop, except that the space beans positioned on the lead drop move up by about 10 cm, so that the main line can move down freely in the lead drop. Therefore, fishing for lead is actually a fishing line. The purpose of lead fishing is mainly to take a skill and tactics to sneak fish. Don't hang the double hook, lead is wrapped on the lead base, and the line group is thrown to the fishing point. At this time, all floating objects will be submerged. Then continue to push the float upward until the number of eyes is exposed, which can expose the tip of the float tail or about 1 eye. The search ends here. Then the distance from the exposed drift tip or 1 mesh to the vertical drop is the water depth.

It's also very important not to throw a full pole when looking for the bottom. Because when we throw the rod normally, the drop point of the lead is in front of the float. If the pole is full, the wind line will float, and the float can't keep up with the falling point of lead, so the waterline where lead falls to float is inclined, and the water depth at the bottom is actually greater than the actual depth. For example, the actual water depth is two or two meters, and the water depth obtained by throwing all the poles out may be 2.5 meters. Using the water depth obtained at this time to adjust the drift, it is very likely that the double hook is not completely off the bottom. How can you adjust the drift? Solution: Don't throw all the poles out or pull them back a certain distance.

Pull-down drift, the distance of pull-down drift is 1 long line plus about/kloc-0-15cm, so after hanging the double hook, the distance between the lower hook and the bottom is 10- 15 cm, which is the so-called "semi-water state". After hanging the double hook, make sure that both the double hook and the lead pendant are suspended in the water, which is closest to the bottom of the water and the drift adjustment will be the most accurate. At the same time, the four space beans used to fix the floating base also move down at the same time.

Throw the wire group into the water, and determine the dressing amount of lead according to the sinking speed of the float. Cut more if you sink fast, and cut less if you sink slowly. In order to adjust the drift quickly, the drift sinks every time you throw it into the fishing spot, and it is not necessary to press the wind line first. Trim the lead until the floating adjustment is made to display the set grid, and it doesn't matter if the display is less.