The tying method of fishing line and the order of parts. I see. Let's go

A line with two hooks. Because it has an extra hook tied to a line, it increases the chance of fish biting the hook when fishing. As early as the thirties, when I was a child, I liked to go fishing in rivers and streams with my parents. I remember once my uncle went fishing in the river in our club beach. When he lifted the fishing rod, two big crucian carp were hoisted out of the water at the same time. They danced and struggled in a line ... These childhood memories always came to my mind.

In the traditional fishing group, it is customary to tie a hook at each end of a 40 cm long fishing line, fold it to a height of 5- 10 cm, and tie a sinker 3-5 cm above the long line to connect with the bus. Someone tied the auxiliary hook to the sinker of the main hook, which became the double hook usage.

Since Taiwan fishing was introduced to the mainland, the advantages of double hooks in Taiwan fishing groups have been recognized and imitated by fishermen. When it is used for leisure fishing, it has accumulated a lot of good experience in continuous reform and innovation. So in recent years, many articles introducing the experience of double hook fishing have been published in relevant fishing magazines. Such as "a double hook fishing method", "a method to solve the problem that double hooks are easy to entangle", "a double hook knot method" and so on. This shows that the majority of fishermen attach importance to the use of double hook and one line, and have explored many good experiences in practice.

In my fishing life for more than half a century, I feel that although there are many introductions of single-line and double-hook experience, some methods are complicated to make and difficult to popularize. The method of "adjustable double hook system method" is: "tie the 8 cm long sub-line to the bus, but still move it hard." According to the above requirements, and after repeated tests, the actual effect is really bad. It is easy to fix the secondary line to the bus. However, in actual operation, due to the tight fastening of the sub-hook wire, when the fish paddles or lifts the wire, the tightly fastened sub-hook wire will also slide down under the pull of the fish and the resistance of water. When passing by, the bus will be pulled, pressed, bent and deformed, damaging the wires. In addition, damaged and bent busbars and sub-wires are easily entangled with each other. For example, the line of the secondary hook is slightly loose (because the two lines are not dead knots). When throwing the rod and lifting the line, the auxiliary hook is easy to slide down automatically. In fact, the main hook of this "adjustable double hook system method" cannot adjust its action. Adjustable double hook is just an empty name.

After learning the failure experience and lessons of using single-line double hook, it also aroused my desire for innovation. How can we really become a convenient and easy adjustable double hook?

How to make the main hook and the auxiliary hook not only have good holding power on the bus, but also can adjust the up-and-down distance at will, which is convenient and fast for bottom fishing, floating fishing, deep fishing and shallow fishing. In addition, you can hit the rubber particles hard, and the bus will not bend, deform or be damaged, so it is very durable. After groping, I finally succeeded. This paper briefly introduces the method of making and using this convenient, fast and effective adjustable single-line double hook to fishermen.

Selection and preparation of materials:

1. Choose a small piece of elastic and unaged automobile inner tube film (it is convenient and easy to find the discarded film of the shoe repair booth that the master wants) or find a piece of tape to let the children jump on the rubber band.

It is required to be flexible and not aging before use. Otherwise, the effect is not good:

2. Buy some 8-12 fine embroidery needles for later use. The thinner the needle used, the better its retention performance if it is worn on colloidal particles.

3. The thickness of the mother-child line, the size of the hook and the collocation of drifting are all used according to the habits of fishing friends. For hand fishing, prepare a bus bar as long as the pole. Sublines can be composed of the same lines as the 1-2 bus or fewer lines than the 1-2 bus. When adjusting the drift, adjust the sinking force of the hook and the buoyancy of the drift to a basic balance. The back of the main hook touches the bottom. Loose floats are very sensitive when floating on the water. It is used for fishing. The hook rate is high.

Manufacturing and assembly:

Production method: when making, use scissors to cut the edge of the film. Cut out two long colloidal particles A and B, and the size of mung bean is about 0.5 cm. Colloidal particles are used to keep the movable auxiliary hook. B is used to keep the movable lead pendant. But it can't be cut off. When assembling, a small connection point should be left for easy operation. After practice, colloidal particles can not be replaced by space beans because their retention is not as good as long colloidal particles.

Assembly method: When assembling, use a fine needle to pass through one end of the bus bar, and then use a needle to pass through all the loose floats one by one "Insert a vertical float through the float seat or the small ring of the valve core with a vertical float". Then, the needle passes through the long vertical direction of the movable rubber particles, and the needle thread is drawn out. Use the above method again, thread the second movable rubber particle B on the bus bar, and take off the needle. Then tie the main hook to the end of this line. Gently tie the sinker to rubber particle B, and cut off the excess wire tail.

Put the needle on the 20-cm-long accessory brain thread, then put the needle through the glue particle of the same length A on the bus bar, pull out the needle thread, and take off the flower needle. Subsequently, that end of the short strand and the long strand which penetrate each other are tied with each other in the middle of the long glue material, and the short strand tail is cut off; finally, the auxiliary hook is tied at the long strand end, and the distance between the hook and the glue particle is generally 3-5cm long, and the redundant strand tail is cut off. In this way, the assembly work of this veritable one-line adjustable double hook fishing group is completed and can be stored for later use (as shown in the picture).

How to use:

1. If you use the main hook to catch bottom fish, use the familiar single hook fishing method. In addition, when fishing in an environment with more mud and rotten grass at the bottom of the fishing point, the hook bait is buried in it. The angler can move the B hook up in time (the lead pendant moves up at the same time), which can increase the length of the main hook, make the hook bait higher than the mud and rotten grass, and make the fish see the delicious food on the hook. They will definitely compete for food, bite the hook and catch more fish at once.

2. The auxiliary hook is mainly used for hanging fishing, which is used to catch pelagic fish. It has the characteristics of large range of activities; It can be adjusted from semi-water to downward floating. Fishing grass carp and silver carp is very convenient and effective. The bottom can be moved to the vicinity of the main hook. It is used to catch fish such as crucian carp, which likes to swim in the water for food. The effect is particularly good.

The specific method is: when using the secondary hook to fish, the fisherman pulls the main hook bus with his left hand, and gently touches the movable A colloidal particle with the secondary hook with his thumb and fingers of his right hand. If the water level needs to be fished deep, the movable colloidal particles will move in the drifting direction until they reach the required distance. If you want to fish shallowly, you can move particle A to the main hook by rowing straight. Explore the swimming level of fish in this way.

Use advantages:

1. Fishing rod group fishing method with one line and two hooks. First of all, tying an extra hook to a line can increase the chance of fish biting the hook. Combining the fishing method of two hooks, one meat and one dish, you can fish in many places. Secondly, it is easy to know that it likes eating meat or vegetarian diet, so it is easy to use bait for fish. The bait is in the right mouth, and the basket is full of fish. For fishermen, fishing in unfamiliar environment is particularly important.

2. In the waters with much silt and rotten grass, when the fish don't bite the hook, they can touch the rubber particles of movable hook B in time to increase the length of the main hook brain line. When the brain line is long, the bait will naturally show mud, which avoids the disadvantage that the bait is buried by sundries and it is difficult to catch the bait.

3, the adjustment range of the main hook and the auxiliary hook is large, and the bottom floating distance can be adjusted according to different situations of the fish; Fishing grass carp and silver carp in the middle and upper layers is very convenient and effective.

4. Because the movable double hook assembled by colloidal particles is used for fishing, it not only has good retention, but also facilitates the main hook and the auxiliary hook to move up and down. No matter how you move it, it won't damage the bus. At the same time, it is also suspended bottom fishing, deep fishing and shallow fishing, and the water level can be adjusted according to the situation of fish. After years of application and practice, it can not only make fishermen handy, but also effectively catch grass carp and crucian carp.

If the penetrating colloidal particles have poor retention, one more particle can be penetrated under the colloidal particles to increase their retention. In addition, the secondary hook has long been used to catch big fish or fishing groups. When the colloidal particles automatically slide down and shift, the fisherman can easily move them back to their original positions when loading bait, and can use them as usual. Fishing friends who like double hook fishing, if they use different double hook methods, the fishing effect is not good, so give it a try and see whose method is simpler and easier to use.