How to install accessories on the pressure cooker cover

Install the fittings on the pressure cooker cover according to the following steps:

1, cleaning and preparation. Before installation, ensure that all accessories are clean and original accessories (such as sealing rings, safety valves, etc.). ) has been disassembled or removed correctly.

2. Install the sealing ring. Apply a new sealing ring to the bottom of the pot cover to ensure that it is evenly attached to the bottom of the pot cover without distortion or flattening, then put the pot cover on the pot and tighten the screws from top to bottom to ensure that each screw is tightened to the same degree.

3. Install safety valves and other valves. Insert the safety valve into the hole on the lid of the pressure cooker, tighten the valve cover to make it fit closely with the installation hole, then put the rubber gasket next to the safety valve on the valve cover, and gently press it with your fingers to make it fit firmly on the valve cover.

4. Install the handle and pressure limiting valve. Combine the handle with the handle, fix it with screws, then fit the fixed handle with the hole on the cover of the pressure cooker, put the screws in the hole and tighten them, then pick up the pressure limiting valve and put it in the corresponding position on the cover, and press it hard to install it.

5. Install other accessories. According to the specific model and design of pressure cooker, it may be necessary to install fusible parts, cams, water level gauges, exhaust valves, etc. These accessories are installed in different ways, but usually involve inserting the accessories into the corresponding holes and fixing them with screws or similar tools.