Correct method of geothermal cleaning

The correct methods of geothermal cleaning are pulse geothermal cleaning and projectile geothermal cleaning.

1, pulse geothermal cleaning method. A common cleaning method is pulse cleaning, which mainly uses some vibration waves generated by gas-water mixing of water and gas to impact the inner wall of geothermal pipeline, thus achieving the cleaning effect. This method is simple to operate and has a good cleaning effect, and will not bring adverse effects to the surrounding environment.

2. Projectile geothermal cleaning method. Projectile cleaning is also a geothermal cleaning method. Projectile cleaning mainly uses the impulse of gas. The operator disengages the geothermal pipeline from the water separator, then puts the cleaning bomb into the geothermal pipeline, and then sprays the cleaning bomb into the geothermal pipeline with an air gun and comes out from the other end of the pipeline to achieve good cleaning effect.

Matters needing attention in geothermal cleaning

When cleaning geothermal water, tighten all connection parts to prevent leakage. When connecting, be sure to insert the pipe to the end, and when disassembling, be sure to push the snap ring down. Be sure to insert the blowdown end into the sewer to prevent pollution to the surrounding environment.

When pulse cleaning, we must pay attention to the state of the pressure gauge on the digital computer pulse generator. When pulse studio and pressure gauge can't respond, the system is blocked. We should stop the construction, analyze the reasons and solve the problems. When the local hot cleaning meets the construction environment and the water source and sewage discharge point are far away and the pipeline length is not enough, it can be linked by itself.