How to install the bath bar, the installation of the bath bar precautions

We in the design of the house will have a bathroom planning, in the bathroom there will be a lot of bathroom equipment, such as, toilet, bath cabinet, basin, etc., there is also the installation of the bath bar, which can bring us warmth in the winter can also give us lighting, then how to install the bath bar? What are the precautions for the installation of the bath bar? If you want to understand with the flash home repair network of the editor together to see a look at it.

One, how to install the bath heater

1. Do a good job of preparing for the installation of the bath heater. After the home bathroom ceiling work is done, we must first open the wind hole as well as the installation of the ventilation window, the general ventilation window ventilation pipe needs to be about 1.5m, and in the installation of the installation should pay attention to the center of the bathtub installation location, the ventilation hole distance should not be more than 1.3m.

2. Determine the location of the bathtub installation

In order to achieve the best heating effect, the bathtub should be installed in the bathtub or bathing room in the center of the center directly above the ceiling. The ceiling. Ceiling ceiling please use the better strength and not easy to **** Ming material, after installation, the height of the bulb from the ground should be between 2.1-2.3M. Too high or too low will affect the use of the effect.

3. Finally then install the bath, bath installation process: ceiling installation preparation - remove the mask (unscrew the bulb, the spring from the mask of the ring off the mask) - wiring (with a soft line will be the bath as well as the switch panel connected) --Connect the ventilation pipe --Push the box into the air hole --Fix the bath light --Install the mask.

Second, the installation of the bath bar precautions

1. First of all, we have to determine the shower when we are in the position of the human body and the distance from the bath bar, the human body back of the upper back is the location of the installation of the bath bar. The reason why the bath is installed in the back of the human body above the back, in addition to the heat of the bath can heat the air in the bathroom, more direct heat radiation to the back of the human body. Because when bathing, people feel the coldest is the back.

2. Then in the ceiling hole size is not allowed to be larger than the sample 5mm, mezzanine space is not enough ceiling holes, should make the installation of the bath after the completion of the gap around the bath no more than 3mm. 2.5m above the space must be used to install the bracket, if the user insists on not using the bracket, it is necessary to declare to the user, the installation of the bath is too high, affecting the use of the effect of the use of brackets must be added to the installation of the spring washers, flat washers.

3

3. Bar should be installed in the center of the bathroom. Many families will be installed in the bathtub or shower position above, so that the surface seems to warm up quickly in winter, but there are security risks. Because the infrared radiation lamp heating fast, too close to the human body is easy to burn. The correct method should be installed in the center of the top of the bathroom bathtub, or slightly close to the location of the bathtub, so that both safety and maximize the function of play.

Bathroom heater is a part of the bathroom can not be missing, so we have to have a certain understanding of it, then how to install the bath with its installation of precautions which, through the introduction of the above small make up everyone for these also understand it, that if you still want to understand