Do it yourself cupboard tutorial

Making your own cabinet is divided into six steps: the first step is to prepare the corresponding materials, the second step is to make the cement cabinet base, the third step is to cut tiles as needed, put wood in aluminum alloy, the fourth step is to lay tiles and cement, the fifth step is to install vertical plates, adjust the drawer track position, and the sixth step is to pour concrete, and you are done.

1, materials needed for homemade cabinets.

Brick, cement, sand, damp-proof board, aluminum alloy, drawer track and other materials are needed.

2. Self-made cement cabinet base. The height of the cabinet is generally about 780cm, and the base 150cm+ cabinet 600cm+ countertop 50cm=800cm.

3, according to the specific size, cutting tile size, cutting tiles, drilling into the water, you need to use a glass drill, and you need to keep watering when drilling, so that a hole is almost one minute. You can put wood in the aluminum alloy, so that you can tighten the screws and make the whole cabinet stronger. You need to screw a screw in the middle of the aluminum alloy.

4. Invert the tiles on the platform, and the countertop tiles also need to be inverted. After paving, stick the upper edge on the outer edge. It should be noted that the upper edge of the edge should be on the same horizontal line, and the smaller the error, the better. It should be controlled at 1-2mm. Then spread cement mortar about two centimeters thick.

5. Tiles should be paved correctly, and the riser position must be kept well. Install the riser and drill holes in the shelf in advance. Also, fix the drawer track in advance, and then adjust the track to the best position.

6. Tie up the reinforced countertop, pour concrete on it, and it will be firm, and a cabinet will be ready. Note: the thickness of cabinet door panel is 18mm.