Installation steps of Pingliang new led street lamp

The installation steps are as follows:

Tools: electric screwdriver, cable, digital multimeter, etc.

1. Connect the main cable to the main line in the lamp post through the terminal block and connect it to the ground wire. Make sure the connection is firm and not loose.

2. Check the circuit with a digital multimeter to ensure that the circuit is unobstructed and there is no short circuit or open circuit.

3. Install the lamp on the main pole. Pay attention to handle with care, so as not to damage the lamp.

4. Tighten the screws and fix the lamp. Ensure that the lamps are stable and will not shake or fall off.

5. Adjust the installation angle and stretch the cable in the lamp post to ensure that the irradiation direction and range meet the design requirements.

6. Connect the power supply and test it to ensure that the street lamp works normally.