Line combination solution of sliding line fishing method

The schematic diagram of the line group of lead fishing method is as follows:

1. In case of heavy lead operation, it is necessary to increase the buoyancy lead on the lead base and increase the hook of 1-2, such as changing the hook No.3 to the hook No.4 or 5.

2. There is another sub-line that is half shorter than normal, and ten centimeters is enough. The space beans above the seat are spread five to ten centimeters, and it is enough to float around to expose a certain number of eyes.

3, and trot lead, to stand upright to the end, change the hook to 1-2, you can change the third to the fourth or fifth, and the sub-line should be half shorter than usual, within ten centimeters.

4. Just above our lead base, the space beans will open five to ten centimeters and float until a certain number of eyes can be exposed.

The so-called lead slip is actually not a lead drop, but a float. When configuring the wire group, open the space bean that locks the lead pendant, so that the wire group can slide between the two space beans. According to the length of the float, the interval is generally set to 8~ 15 cm. After the fishing group entered the water, the lead fell heavily and sank directly to the bottom of the water.

Heavy lead fishing method:

Different from the slide lead fishing method, when the heavy lead fishing method is used, the lead pendant and the float are tight, but not necessarily perpendicular. If you throw the lead pendant and the floating seat far away, it will even form a small angle with the bottom of the water. If this happens in the lead-sliding fishing method, then the lead-sliding fishing method will become the heavy lead fishing method.