13 hook method solution

The main steps of 13 hook system graphic method are as follows:

1. Hold the hook with your left hand and bend the fishing line into a circle as shown in the figure. Pay attention to leave enough length at the ends of both sides.

2. Hold the right wire of the coil interface with your right hand and wind the fishing line on the hook handle. Note that the right thread end and hook handle should be wound together at the same time.

3, a * * * winding 4-5 times, should not be too much.

4. After winding enough times, hold the winding with your left hand, as shown in the figure, and then hold the thread end of the winding with your right hand to pull it out.

5. Pull it all the way to the back of your head and tighten it hard. At the same time, pay attention to avoid excessive force at the hook tip to hurt your hand. It is also important to make the direction of the fishing line drawn on the inside of the hook handle as shown in the figure, because the head fixing piece of the hook handle is inclined outward. If the fishing line is left on the outside of the hook handle, it will often cause the hook handle fixture to wear the fishing line, which will lead to the deviation of the fish.

6. Finally, subtract the extra thread with scissors.

7. The hook at one end of the sub-line is knotted, and the hook at the other end can also be used in the same way.

Supplement:

The method of knotting the fishhook to prevent the secondary line from winding has advantages and disadvantages. The advantage is that even small substrings are not easily entangled, and the disadvantage is that the signal of fish eating bait will be slightly weakened. If you are a novice or a wild fisherman, this method of tying the fishing line is still relatively easy to use.