Use of mesh belt conveyor

Before the mesh belt conveyor runs, first ensure that the equipment, personnel and conveyed articles of the mesh belt conveyor are in a safe and sound state; Secondly, check whether all moving parts are normal and whether all electrical circuits are normal. Only when they are normal can the belt conveyor be put into operation. Finally, check that the difference between the power supply voltage and the rated voltage of the equipment does not exceed 5%. The specific operation of the belt conveyor is as follows: 1. Turn on the main power switch and check whether the equipment power supply is normal and whether the power indicator light is on. Proceed to the next operation after it is normal. 2. Close the power switch of each loop and check whether it is normal. Under normal circumstances, the equipment is not running, the running indicator of belt conveyor is off, the power indicator of frequency converter and other equipment is on, and the display panel of frequency converter is normal. 3. Start the electrical equipment in turn according to the process flow. After the last electrical equipment is started normally, start the next electrical equipment. 4. In operation, the mesh belt conveyor must comply with the design of the conveyed articles and the provisions of the conveying capacity of the mesh belt conveyor. Secondly, it should be noted that all kinds of personnel are not allowed to touch the moving parts of the belt conveyor, and non-professionals are not allowed to touch the electrical components and control buttons at will. Finally, in the operation of the belt conveyor, the rear stage of the frequency converter cannot be disconnected. If the maintenance needs are determined, it must be carried out under the condition of stopping the frequency conversion operation, otherwise the frequency converter may be damaged. 5. When the belt conveyor stops running, press the stop button until the system stops completely, and then cut off the main power supply.