Installation steps of sliding wardrobe door slide rail

When installing a wardrobe in the bedroom, you need to pay attention to the installation track. What are the steps to install the sliding rail of the push-pull wardrobe door? PChouse, let's take a look.

Tracking frame size

The track box above the sliding door should be 12 cm high and 9 cm wide. The sliding door can be hung on the rail by installing the rail in the rail box. If the height of the door is lower than 1.95m, it may make people feel depressed. Therefore, when making sliding doors, we must ensure that the height is at least 207 cm.

gold lacquer

The width-height ratio of sliding doors should be close to the size of gold. Generally speaking, the size of a normal door is about 80 cm× 200 cm, because under this structure, the door will be relatively stable and visually more beautiful.

Avoid using open hanging track boxes.

It is best not to use sliding doors (open rail boxes) from the ground to the top. Because the swing amplitude is too large when pushing and pulling, the sliding door is easy to deform over time, and the deformed back door can't be opened, which means it can't be maintained and used.

Track installation

Finally, the track for installing sliding doors. Fix the upper rail, then use gravity cone (hanging wire hammer) to hang three points at both ends and midpoint of the upper rail, draw a three-point fixed surface on the ground, then install the upper rail, and then put a hanging hammer at the center of the upper rail to the ground. Vertical lines should be placed at both ends of the cross bar, and the lower cross bar should be fixed at these three points, so as to ensure that the upper and lower cross bars are completely parallel, and the push and pull of the sliding door will be in the best state.